Pioneer DV-05 Optical, Fiber cable, Coaxial cable Cord with a mini plug no resistance, 3.5ø

Connecting the Player

Connection example 1.

AV amplifier with built-in decoder Use this connection to connect an:

•AV amplifier with built-in Dolby Digital (AC-3) decoder

•AV amplifier with built-in DTS decoder AV

•AV amplifier with built-in MPEG decoder, etc.

When connecting to the digital inputs of an AV amplifier with built-in decoder.

Preparation

•Connect the digital output jacks of this player to the digital input jacks (Dolby Digital (AC-3), DTS, MPEG) of the decoder included AV amplifier.

•Set the DIG. OUTPUT on the menu during stop mode to match the connected AV amplifier. (Page 35)

OperationBasic

Optical

						COMPONENT
						VIDEO OUT
DIGITAL OUT			VIDEO OUT	S-VIDEO OUT		Y	AUDIO OUT
OPT.	CONTROL		1	1	2	CB	R	L
							1
	IN	OUT
			2			CR	2
								AC IN

fiber cable

CONTROL

OUT

Coaxial cable

Cord with a mini plug (no resistance, 3.5ø)

AC-3/PCM

DIGITAL IN

LD

1

2

AV amplifier with with

built-in decoder

Finally, connect to a home wall outlet.

	S-Video cable
VIDEO IN S-VIDEO IN

Accessory video cord

Setup

Center speaker

Sub woofer

Surround	Front	Front
speaker	speaker	speaker

Diagram of example component set up for DVD surround audio.

Surround

speaker

Audio output connection can be made using either the COAXIAL DIGITAL output or the OPTICAL DIGITAL output and video output connection can be made using either the S VIDEO OUT or the VIDEO OUT.

OperationDetailed

•When connecting to a component bearing the Pioneer Î mark:

If you use a commercially available cord with a mini plug (no resistance) to connect this player’s CONTROL IN jack to the CONTROL OUT jack of another component bearing the Î mark, you can control the player as though it were a component in a system (system control).

•If you connect for system control, you cannot operate the player directly by pointing the remote control at it and pressing buttons. Point the remote control unit at the component (AV amplifier etc.) connected to the CONTROL OUT jack for operation.

•When controlling as a system, be sure to make connection to the amplifier using an audio cord or a video cord even when

using only digital components.
		Note
• For more details, refer to the connected component’s operating
		Cables can be found at your local audio/video dealer.
instructions.
	There will be no sound output from the AUDIO OUT
	jacks during DTS audio playback.

InformationOther

Connecting the Player

15

<VRB1205>