Toshiba 42LX177 manual Using the Hdmi settings feature, To set the CE-Link Setup

Chapter 6: Using the TV’s features

To set the CE-Link Setup:

1 Press Yand open the Setup menu.

2 Highlight CE-Link Setup and press T.

Setup

Installation

CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Slide Show Interval	2 Sec
Power-On Mode	Power-Saving
Demo Mode	On

3 Press B or b to highlight Enable CE-Link.

CE-Link Setup

Enable CE-Link		On
TV Auto Input Switch		On
TV Auto Power		Off
Device Auto Standby		On
Speaker Preference		TV Speakers
	Reset	Done

4 Press C or c to select On.

Note: If you set Enable CE-Linkto Off, the all other items will be grayed out.

5 Press B or b to highlight the CE-Linksetup item you want to use, and press C or c to select On/Off or the desired speakers mode.

•TV Auto Input Switch: On/Off

•TV Auto Power: On/Off

•Device Auto Standby: On/Off

•Speaker Preference: TV Speakers/Audio Receiver (See details on the previous page.)

CE-Link Setup

Enable CE-Link		On
TV Auto Input Switch		On
TV Auto Power		Off
Device Auto Standby		On
Speaker Preference		TV Speakers
	Reset	Done

6 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T.

Using the HDMI settings feature

This menu consists of the following 3 items (new HDMI capabilities) and will be grayed out on non-HDMI inputs.

Some HDMI legacy sources may not work properly with your HDMI TV, please try setting the following three options (Lip- Sync Latency, Deep Color, and xvYCC) to Off. Adjusting these settings should allow your HDMI legacy source to operate properly with your TV.

•Lip-Sync Latency: On

This option activates an auto audio/video display timing adjustment function that allows HDMI source devices to accurately perform synchronization automatically.

•Deep Color: On

This feature allows to HDMI source to increase available colors bits within the boundaries defined by the RGB or YCbCr color space.

•xvYCC: On

This feature expands the acceptable color range (limits) in the HDMI signals, then allows sending wider color signals from HDMI source.

All above HDMI settings need proper HDMI source device. If HDMI source products does not support these features, the TV may not work properly by activating these features.

Note: If your HDMI connection is capable of 1080p and/or your TV is capable of refresh rates greater than 60Hz or supports Deep Color, you will need a Category 2 cable. Conventional HDMI/DVI cables may not work properly with this mode.

To set the HDMI Settings:

1	Select the appropriate HDMI input mode (HDMI 1,
	HDMI 2, or HDMI 3).
2	Press Yand open the Setup menu.
3	Highlight HDMI Settings and press T.
4	Press B or b to highlight the item you want to set.
		HDMI Settings		HDMI 1
			Lip-Sync Latency	On
			Deep Color	On
			xvYCC	On

Once you have changed On/Off settings, please press

Done and wait for changes completed message.

Warning: DO NOT TURN OFF OR UNPLUG THE TV UNTIL

COMPLETED MESSAGE IS DISPLAYED!!

		Reset	Done
5
	Press C or c to select On or Off .
6	To save the new settings, highlight Done and press T.
	To revert to the factory defaults, highlight Reset and
	press T.

75