Toshiba 40RF350U manual Using the Hdmi settings feature, To set the CE-Link Setup

Chapter 6: Using the TV’s features

To set the CE-Link Setup:

1 Press Yand open the Setup menu.

2 Highlight CE-Link Setup and press T.

Setup

Installation
CE-Link Setup
Sleep Timer
HDMI Settings
PC Settings
Blue LED Illumination	High

Power-On Mode Power-Saving

3 Press B or b to highlight Enable CE-Link.

CE-Link Setup

Enable CE-Link		On
TV Auto Input Switch		On
TV Auto Power		Off
Device Auto Standby		On
Speaker Preference		TV Speakers
	Reset	Done

4 Press C or c to select On.

Note: If you set Enable CE-Linkto Off, the all other items will be grayed out.

5 Press B or b to highlight the CE-Linksetup item you want to use, and press C or c to select On/Off or the desired speakers mode.

•TV Auto Input Switch: On/Off

•TV Auto Power: On/Off

•Device Auto Standby: On/Off

•Speaker Preference: TV Speakers/Audio Receiver (See details on the previous page.)

CE-Link Setup

Enable CE-Link		On
TV Auto Input Switch		On
TV Auto Power		Off
Device Auto Standby		On
Speaker Preference		TV Speakers
	Reset	Done

6 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T.

Using the HDMI settings feature

This menu consists of the 2 items shown below (new HDMI capabilities) and will be grayed out on non-HDMI inputs.

Some HDMI legacy sources may not work properly with your HDMI TV. If you experience any problems, please unplug your HDMI cable first and then try setting the following options (Lip-Sync Latency and xvYCC) to Off. Adjusting these settings should allow your HDMI legacy source to operate properly with your TV.

•Lip-Sync Latency: On

This option activates an audio/video display timing adjustment function that allows HDMI source devices to accurately perform synchronization automatically.

•xvYCC: On

This feature expands the color range of HDMI signals, allowing input of wider color signals from HDMI sources. The HDMI features require proper HDMI source devices. If your HDMI source device does not support these features, activating them on the TV will not have any effect.

Note: If your HDMI connection is capable of 1080p and/or your TV is capable of refresh rates greater than 60Hz, you will need a Category 2 cable. A conventional HDMI/DVI cable may not work properly with these settings.

To set the HDMI Settings:

1 Select the appropriate HDMI input (HDMI 1, HDMI 2, or HDMI 3).

2 Press Yand open the Setup menu.

3 Highlight HDMI Settings and press T.

4 Press B or b to highlight the item you want to set.

HDMI Settings		HDMI 1
	Lip-Sync Latency	On
	xvYCC	On

Please unplug your HDMI cable first!

Once you have changed On/Off settings, please press

Done and wait for changes completed message.

Warning: DO NOT TURN OFF OR UNPLUG THE TV UNTIL

COMPLETED MESSAGE IS DISPLAYED!!

		Reset	Done
5
	Press C or c to select On or Off .
6	To save the new settings, highlight Done and press T.
	To revert to the factory defaults, highlight Reset and
	press T.

68