Introduction
Identification of controls (continued)
Inserting batteries
Slide the battery compartment | Install two “R03/AAA” batteries | 3 | Replace the compartment |
cover in the direction of the | (supplied), paying attention to the | cover. | |
1 arrow. | 2 polarity diagram in the battery |
|
compartment.
Battery precautions:
The precautions below should be followed when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the
3.Do not mix different types of batteries together (e.g. Alkaline and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
Remote control basics
•Press POWER to turn the unit on or off.
•Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
•Tap CHANNEL 
or 
to move through the channels one channel at a time.
•The Direction buttons (
/
/
/
) are also used to navigate
•You can directly access specific channels using Direct channel selection buttons.
Illustration of MW24FPX
Operation:
•Aim the remote control at the remote sensor and press control buttons to operate.
•Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.
Approx. 5 meters
12
5Q10501A | 12 | 4/17/04, 11:55 AM |