Toshiba 55WX800U, 46WX800U manual Service, To Display your LCD TV on the included Pedestal Stand

Page 5

41)During normal use, the TV may make occasional snapping or popping sounds. This is normal, especially when the unit is being turned on or off. If these sounds become frequent or continuous, unplug the power cord and contact a Toshiba Authorized Service Center.

42)

WARNING: RISK OF

 

SERIOUS PERSONAL

 

INJURY OR EQUIPMENT

DAMAGE!

Never strike the screen with a sharp or heavy object.

43)• The LCD screen of this product can be damaged by ultraviolet radiation from the sun. When selecting a location for the television, avoid locations where the screen may be exposed to direct sunlight, such as in front of a window.

Never touch, press, or place anything on the LCD screen. These actions will damage the LCD screen. If you need to clean the LCD screen, follow the instructions in item 35 on p. 4.

Service

44)

WARNING:

RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Failure to follow this WARNING may result in death or serious injury. Refer all servicing not specified in this manual to a Toshiba Authorized Service Center.

45)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal Stand:

Observe the following safety precautions:

1)Read and Follow the pedestal assembly instructions included with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the front of the LCD Panel face down on a flat, cushioned surface such as a quilt or blanket. Leave the bottom of the unit protruding over the edge of the surface and assemble the pedestal as indicated below.

Note: Extreme care should always be used when attaching the pedestal stand to avoid damage to the LCD panel.

2)Place the TV on a sturdy, level surface that can support the weight of the TV.

3)Be sure to secure the TV to a wall stud, pillar, surface, or other immovable structure. To secure the TV in this manner: (1) attach the provided securement clip to an immovable structure, then (2) pass a sturdy strap

through the securement clip and attach each end to the hooks located on the back of the TV. Be sure to leave at least 4 inches between the TV and the wall or similar structure for ventilation. See item 25, p. 4 for additional details.

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL Listed wall bracket appropriate for the size and weight of the LCD TV (- p. 2) :

CAUTION:

1.Two people are required for installation.

2.Never use the screws attached to the TV.

3.To install a wall-mount from another manufacturer, use the enclosed SPACERS.

1)Unplug and remove any cables and/or other component connectors from the rear of the TV.

2)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket.

3)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

4)Make sure to place the spacers provided with the TV between the bracket and the back of the TV.

5)Always use the screws supplied or recommended by the wall mount manufacturer.

1. Remove the four screws. (Do not use these for attaching a wall bracket.)

2. Place the four spacers (supplied).

Screw

Wall bracket

Spacer (supplied)

TV back panel

Removing the Pedestal Stand

1)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the five screws.

3) Once you have removed all five screws holding the pedestal stand in place, remove the pedestal stand from the TV by

Five screws

sliding the pedestal stand away from the TV.

5

Image 5
Contents 46WX800U 55WX800U Child Safety Installation Additional Safety PrecautionsLike Personal Injury DEATH, or Equipment DamageRisk of Electric Shock CareTo Display your LCD TV using a Wall Bracket ServiceTo Display your LCD TV on the included Pedestal Stand Removing the Pedestal StandDo not drop, exert pressure on, or step on the 3D glasses Observe the following for the battery of the 3D glassesAbout lithium battery FCC Compliance Statement Wireless RadioTrademark Information Page Contents Troubleshooting Advanced featuresAppendix IndexOverview of installation, setup, and use FeaturesIntroduction Energy Star qualifiedBack panel connections Front panel controlsWall Mount type Bundling the cablesStand type About the illustrations Connecting your TVOverview of cable types To view the antenna or cable signal Connecting to Satellite dish, Antenna, or Cable TVYou will need Coaxial cables To view basic and premium cable channelsTo connect an Hdmi device, you will need Connecting an Hdmi or DVI device to the Hdmi inputTo view the Hdmi device video To connect a DVI device, you will needVCR Preferences IR Control Connecting remote IR devicesUsing the IR OUT terminal Using the IR in terminal Connecting a digital audio systemTo set the IR in mode Before controlling the audioHDMIs ARC Audio Return Channel feature Using the TV remote and REGZA-LINKto control other devicesConnecting a Hdmi audio system Connecting to the TV’s PC in terminal Connecting a PCPin Signal Name Connection to the TV’s Hdmi terminalYou will need Standard LAN cables Connecting to a home networkInstalling batteries Using the remote controlControlling other devices Toshiba deviceModes TV , CABLE/SAT , BD , DVD Remote’s buttonsANT/CABLE Initial Setup and MenuInitial Setup Navigating the menu system Setup Quick Setup OKStart Scan If channels are not found after scanningQuick menu Main menu layoutStoring channels in memory optional Setting up your TVChanging Initial settings Skipping video inputs Manual TuningSkipping channels Labeling video inputs Setting the Auto Input featureConfiguring shared inputs Before using 3D function, see the following Basic featuresHealth precautions About the connecting cableSwitching display mode or selecting 3D format Using 3D functionsSetting the 3D PIN code Setting the auto start modePreferences 3D Setup OK Option DescriptionSetting 3D Lock Setting 3D Start MessageSetting 3D Timer Lock Setting Enable 3D TimerSetting the Channel Tuning Mode Tuning channelsTuning to the next programmed channel Using the Channel BrowserUsing SurfLock Using Channel ReturnAdding and clearing channels and inputs in the History List REGZA-LINKSelecting the video input to view Using closed captionsAnalog CC mode Digital CC settings Setting the PIN codeEntering a new PIN code Changing or deleting your PIN codeBlocking TV programs and movies by rating V-Chip Using parental controlsDownloading an additional rating system Preferences Parental Control and Locks OKRating system Displaying ratingsUnlocking programs Locking specific channels Setting a time limit for gamesLocking video input Locking the control panelREGZA-LINKinput source selection Using REGZA-LINKControlling REGZA-LINKplayback devices Preferences REGZA-LINK Setup Adjusting the amplifier’s audioTo set the REGZA-LINKSetup Other REGZA-LINKfunctionsSetting the Hdmi audio mode Using the Hdmi settings featureViewing the Hdmi signal information ModeDescriptionSetting the timer to turn on the TV Using your PC with the TVAdjusting the image Setting the PC audioSetting Automatic Power Down Setting the sleep timerSetting No Signal Power Down Preferences Energy Saving SettingsAdjusting Power LED’s Dimmer Setting Blue ScreenDisplaying TV status information Preferences Blue Screen Press C or c to select On. Press OPower failure Resetting to Factory DefaultsSetup System Information Setup Reset TV OKTo select the picture size Picture and sound controlsSelecting the picture size For 1080i, 1080p, and 720p program sources Full For 169 480i, 480p source programs onlyPicture Size TheaterWide For 43 format programs TheaterWide For letter box programsUsing the 43 Stretch Using the Auto Aspect featureScrolling the picture Freezing the pictureSelecting the picture mode Adjusting the pictureAdjusting the picture quality Picture Picture ModeUsing the advanced picture settings features Mode Descriptiom Backlight Adjustment ProSmart Sensor Room LightingExpert Picture Settings Setting Type Locking the picture settingsViewing the TV’s brightness Copy to All InputsAdjusting the audio balance Adjusting the audioMuting the sound Selecting stereo/SAP broadcastsUsing surround sound Using advanced sound featuresUsing Dolby Volume Using your home network Advanced featuresWhen you enjoy Internet services by wireless Using under wireless LAN environmentWireless Setup Setting up the NetworkEasy Setup using PBC Push Button Configuration Easy Setup using PIN Personal Identification NumberEnhanced 11n Manual SetupWireless Information Advanced Network SetupIP Address Setup DNS SetupMAC Address To cancel the Network Connection TestNetwork Connection Test Performing a Software Upgrade Using the software keyboardSetup Software Licences OK Viewing the Software LicencesGuided Setup Using the NET TV featureNET TV menu NetflixYouTube Preferences Netflix Setup OKButtonDescription Preferences Vudu DeactivationSwitching the frame Switching the pointerTo use the Drag Mode To use Function menuSetting other features Setting the view featureProfile Widget configures your user profile Using the Profile WidgetYahoo! TV Widgets Widgets OKUsing the Widget Gallery Setting up the Media Renderer featureUsing other Yahoo! Widgets Preferences Media Renderer SetupWeb Password Setup Device Name SetupMedia Controller Setup Maximum Volume SetupMedia Player Specifications Using the Media PlayerUsing Media Player with USB and SD Memory Card Basic operationTo display the device information Using Media Player with Dlna Certified ServerSetting Dlna Certified Server waking up Item Description Viewing Movie filesPlaying Music file File specificationsTo display the file status information To use Avchd deviceAdvanced features Viewing Photo files Photo Edit Using the Photo Frame featurePhoto Select Auto Power Off General troubleshooting TroubleshootingTroubleshooting Touch Sensor except Power LED White Touch Sensor Power LED BlueNo light Blue blinksColorStream component video HD Input SpecificationsAppendix Format Resolution Frequency Acceptable signal formats for PC in and Hdmi terminalsPC in signal formats Vesa Standard Hdmi signal formats3D Structure Acceptable signal formats for 3DResolution Aspect ratio Frequency Remote control functional key chart SAT Remote DVD/VCRControl Cable VCR PVRDVD AMP KEY DVD-R Blue Blu-RayHome HomeProgramming the remote to operate other devices Device code setupOperating other devices To unlock the remote’s volume keys Locking the volume keysSearching for a device code Clearing the remote’s programmingBehavior/Mode Operating TV with combination buttonsButton HdmiAudio Amplifier Remote control codesCable Set Top Box Cable/PVR ComboSatellite Set Top Box Audio AccessoryAudio Receiver BrandCode SAT/PVR ComboVideo VCR STS DVD/VCR ComboNAD Video DVDDVD High Definition HD-DVD DVD High Definition Blu-RayLimited United States Warranty Limited One 1 Year Warranty on Parts and Labour Limited Canadian WarrantyDisclaimer and Limitation of Remedy Arbitration and Dispute ResolutionCritical Applications How to Obtain Warranty ServicesGeneral Provisions Wmdrm End User Notice104 Index105 Service Centers