Toshiba 55HT1U manual Setting the ChannelTuningNode

To tune to a channel or input in Select mode:

Whde. watching. TV, press _BACK '_ or _NX1 t_ to open tile

Channel Browser ''_ and surf back to a previous item or tUrwardto the next item in the list.

In Select mode, when you stop on an item in the Channel Browser ''*, it will be highlighted but you

must press @ to tune the TV to the highlighted item.

2Press @ to tune the TV to the highlighted item. Press EXITO to close the Channel Browser '_'.

Addingand clearing channels and inputs in the History List

Adding channels and inputs to the History List:

As a channel or input is tuned, the Channel Browser ''* adds it to the History List and displays it on the "right side" of the Channel Browser _'*.Previously tuned

channels/inputs are "shifted" to the left, eventually moving off the left side. Press [_ "_ to surf backward

through the previously tuned channels/inputs. Any

channel or input that is tuned repeatedly will not be

repeated in the History List, but instead is moved to the end of the list on the right side of the Channel Browser".

The Channel Browser '_' will store the following channels:

*All channels that are tuned using the numeric buttons on the remote control.

*All channels that are tuned using [_ or [_] on the remote control.

Note: Whenever an item is selected that cannot be tuned (for various reasons), the TV will automatically tune to the previously viewed channel or input.

Clearing channels from the History List:

*Reconfiguring the ART/CABLEinput will clear the History List.

Note: See page 24 for details on configuring

the antenna input.

*Once 32 channels or inputs are stored in the History List, the oldest item will be removed from the list

when a new channel or input is tuned.

*Turning off the TV will clear the History List.

Setting the ChannelTuningNode

This feature allows you to choose how tuning will be handled for analog and digital channels when the TV is in Antenna mode.

Note: To use this feature, the Input Configuration must be set to Antenna (_, page 24).

The channel tuning mode has three options.

Standard Both analog and digital channels can be tuned normally

Digital channels will have priority when

manually entering a channel number

Auto

using the Channel Number (0-9) on the

(default)

remote control, analog channels can still be tuned by [_ / [_J, if available

Digital Only digital channels can be tuned

Note: Digital mode will be most useful after analog channels are shut down by the government in 2009.

To set the Channel Tuning Mode:

1From the Setup menu, highlight InstaJJationand press @. A new set of installationmenu icons will appear.

Open the Terrestrial menu, highlight Channel

TuningNode, and then press _ to select your desired mode.

Note:

. The Channel Options windows as well as the Channel Browser ANT/CABLE list will be updated automatically when you change the

mode. Also, the History List will be cleared, but the Favorites List will be saved.

,,Even ff the Channel Tuning Mode is set to Digital, analog channel 3 will still be the default channel to prevent the initial case where no digital channels have been found in prior channel scans. (Channel Options will not have anything listed until a scan is done.)

(confin *¢ed)

32