Using the TV’s features (General)
Resetting the TV
Reset TV will reset all TV settings, including stored channels, to their original factory values.
1 From the SETUP menu, press V or U until Reset TV is selected.
SETUP
ATV Manual Tuning
DTV Manual Tuning
DTV Settings
AV Connection
Picture Position
Quick Setup
System Information
Reset TV
2 Press Qto select.
Ascreen will appear warning that all settings will be lost. Select Yes and then press Qto continue.
When the set powers back on, the Quick Setup screen will appear. Press Qto continue, the TV will then display the Auto Tuning menu (- page 14).
Selecting the video input source
1 Press o on the remote control to display the video input mode list, and then press V or U to select appropriate input source (or press o on the TV side panel or o on the remote control repeatedly to select the desired input source directly).
Inputs
DTV
1
2
3
4
HDMI1
HDMI2
HDMI3
HDMI4
PC
ATV
Ex. PC VGA mode
PC VGA
2 Press Q.
DTV (Digital TV),
o1 (o (1), video 1 input),
o2 (o (2), video 2 input) or o 2S
o 4 (o 4, component video input),
HDMI1, HDMI2, HDMI3, HDMI4 (HDMI input), PC (o RGB/PC, PC input),
ATV (Analogue TV)
Notes:
•When component video, PC, or HDMI input modes are selected, the MONITOR terminals (- page 32) output audio signal only.
•If a
•When the TV is switched on, it will take a few minutes for the
•If the HDMI cable from a connected device or the HDMI device settings is changed, Enable
Setting the Manual Settings menu - analogue only -
1 Press M, and then press Y or Z to display the SETUP menu.
SETUP
Menu Language | English |
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
DTV Settings
Manual Settings
AV Connection
Picture Position
2 Press Vor U to select Manual Settings, and then press Q.
3 Press Y or Z to select an item, and then press V or U to select the item as shown below.
Manual Settings
Colour System: Auto
EXT1 A
A B
A. Colour System
Confirm that colour system is set to “A” (Auto). If not, select “A” with V or U.
B. Video label
The video label allows you to label each input source for your TV.
To change or create video labels:
1)Press V or U repeatedly to select a character for the first space, and then press Z.
*(blank space)
2)Repeat step 1 to enter the rest of the characters. If you would like a blank space in the label name, you must choose a blank space from the list of characters.
3)Press Qto store your settings.
24