Chapter 6: Using the TV’s features
Setting the PC Audio
This function allows you to output or mute the sound from your PC when connecting using the PC IN terminal and an analog RGB cable. ( page 20)
To set the PC Audio:
1 Press 
and open the Audio menu.
2 Highlight Audio Setup and press 
.
3 Press S or T to select PC Audio and then press W or X to select No or Yes.
Yes: When viewing the PC input, the audio from the PC Audio input can be heard.
No: When viewing the PC input, there will be no audio.
Note: Because the PC and
Setting the sleep timer
You can set the sleep timer to turn off the TV after a set length of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press 
on the remote control to set the length of time
until the TV turns off. Repeatedly press 
to increase the time in
To set the sleep timer using the on-screen menus:
1 Press 
and open the Setup menu.
2 Highlight Sleep Timer and press 
.
3 Press the Number buttons to enter the length of time in
4 Highlight Done and press 
.
Note: When a power failure occurs, the sleep timer setting may be cleared.
To display the remaining sleep time:
Press 
.
Note: A message will display
To cancel the sleep timer:
Repeatedly press 
until it is set to 0 minute.
Using HDMI Control
This is a new feature that uses CEC technology. CEC is an optional protocol used in HDMI systems that allows HDMI devises to pass control functions such as “TV Auto input Swtch” and “Device Auto Stanby” along to devices within the system.
When the Enable HDMI Control and each item in the HDMI Control Setup menu are set to On, the following functions will be enabled.
Item | Description |
TV Auto | If a connected HDMI device starts playing |
Input | video or audio, the TV will automatically |
Switch | switch to the appropriate HDMI input. |
|
|
TV Auto | If a device is turned on, the TV turns on |
Power | automatically. |
|
|
Device | If the TV is turned off the TV will send a |
Auto | message to turn off all of the devices connected |
Standby | to the TV. |
|
|
Note: These functions depend on the devices that are connected. Please check the manual for the devices.
To set the HDMI Control Setup:
1 From the Setup menu, highlight HDMI Control Setup and press 
.
2 Press S or T to highlight Enable HDMI Control.
3 Press W or X to select On.
Note: If you select Enable HDMI Control Off, the other items will be grayed out.
4 Press S or T to highlight the HDMI Control Setup item you want to use, and press W or X to select On or desired mode.
•TV Auto Input Switch: On/Off
•TV Auto Power: On/Off
•Device Auto Standby: On/Off
5 To save the new settings, highlight Done and press 
. To revert to the factory defaults, highlight Reset and press 
.
50