Pioneer DVR-320-S Additional information Condensation, Hints on installation, Moving the recorder

Page 95

Additional information

Condensation

Condensation may form inside the recorder if it is brought into a warm room from outside, or if the temperature of the room rises quickly. Although the condensation won’t damage the recorder, it may temporarily impair its performance. For this reason you should leave it to adjust to the warmer temperature for about an hour before switching on and using.

Hints on installation

We want you to enjoy using this unit for years to come, so please bear in mind the following points when choosing a suitable location for it:

Do...

Use in a well-ventilated room.

Place on a solid, flat, level surface, such as a table, shelf or stereo rack.

Don’t...

Use in a place exposed to high temperatures or humidity, including near radiators and other heat- generating appliances.

Place on a window sill or other place where the recorder will be exposed to direct sunlight.

Use in a dusty or damp environment or in a room where it will be exposed to excessive cigarette smoke.

Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use.

Use near a television or monitor as you may experience interference—especially if the television uses an indoor antenna.

Use in a kitchen or other room where the recorder may be exposed to smoke or steam.

Use on a thick rug or carpet, or cover with cloth—this may prevent proper cooling of the unit.

Place on an unstable surface, or one that is not large enough to support all four of the unit’s feet.

13

Manual recording modes

The table below shows the approximate recording times for all of the 32 manual recording modes, as well as the standard recording mode equivalents. Levels separated by a bold line show where there is a noticeable change in picture quality.

Audio recording in all manual recording modes is in Dolby Digital 2ch format, except for MN32 which is in Linear PCM format.

VR mode

 

 

Video mode

Level

Rec. time

 

Level

Rec. time

 

 

 

 

 

MN 1

360 mins.

EP

MN 1

360 mins.

MN 2

345 mins.

 

MN 2

345 mins.

MN 3

330 mins.

 

MN 3

330 mins.

MN 4

315 mins.

 

MN 4

315 mins.

MN 5

300 mins.

 

MN 5

300 mins.

MN 6

285 mins.

 

MN 6

285 mins.

 

 

 

 

 

MN 7

270 mins.

 

MN 7

270 mins.

MN 8

255 mins.

 

MN 8

255 mins.

MN 9

240 mins.

 

MN 9

240 mins.

LP

MN 10

230 mins.

 

MN 10

230 mins.

MN 11

220 mins.

 

MN 11

220 mins.

MN 12

210 mins.

 

MN 12

210 mins.

MN 13

200 mins.

 

MN 13

200 mins.

MN 14

190 mins.

 

MN 14

190 mins.

MN 15

180 mins.

 

MN 15

180 mins.

MN 16

170 mins.

 

MN 16

170 mins.

 

 

 

MN 17

160 mins.

MN 17

160 mins.

 

MN 18

150 mins.

 

MN 18

150 mins.

MN 19

140 mins.

 

 

 

 

MN 19

140 mins.

MN 20

130 mins.

 

MN 20

130 mins.

MN 21

120 mins.

SP

MN 21

120 mins.

MN 22

110 mins.

 

MN 22

110 mins.

MN 23

105 mins.

 

MN 23

105 mins.

MN 24

100 mins.

 

MN 24

100 mins.

MN 25

95 mins.

 

MN 25

95 mins.

MN 26

90 mins.

 

MN 26

90 mins.

MN 27

85 mins.

 

MN 27

85 mins.

MN 28

80 mins.

 

MN 28

80 mins.

MN 29

75 mins.

 

MN 29

75 mins.

MN 30

70 mins.

 

MN 30

70 mins.

MN 31

65 mins.

 

MN 31

65 mins.

MN 32

61 mins.

 

MN 32

61 mins.

FINE

Moving the recorder

If you need to move the recorder, first remove the disc, if there’s one loaded, and close the disc tray. Next, press STANDBY/ON to switch the power to standby, checking that the POWER OFF indication in the display goes off. Lastly, disconnect the power cord. Never lift or move the unit during playback or recording—discs rotate at a high speed and may be damaged.

95

En

Image 95
Contents DVR-320-S LASERPRODUCTCLASS1 Operating Environment POWER-CORD CautionContents Additional information Language settings Recording settings Playback settingsResetting the recorder Setting up the remote to control your TVBefore you start Chapter FeaturesBefore you start Before you start Before you start What’s in the box Putting the batteries in the remote controlUsing the remote control Compressed audio compatibility General disc compatibilityDVD-R/RW compatibility CD-R/RW compatibilityPC-created disc compatibility WMA Windows Media Audio compatibilityJpeg file compatibility Original Front panel connections Connecting upConnecting up Chapter Rear panel connectionsVCR Connecting up Easy connectionsConnecting using the component video output Connecting up Using other types of video outputConnecting using an S-video output Connect RF antenna cables as shown This enables you to watch and record TV channelsThis enables you to watch the output from this recorder This enables you to watch discs This enables you to listen to multichannel surround sound Connecting up Connecting to an AV amplifier or receiverAfter checking all the connections, plug in the recorder Connecting up Connecting other AV sourcesConnecting a VCR or analog camcorder PluggingFront panel Controls and displaysControls and displays Chapter Fine Controls and displays DisplayPlay REMPause Controls and displays Remote controlReturn REV Scan / FWD ScanStop REC Controls and displaysPrev / Next Getting started Chapter Switching on and setting upGetting started Enter Getting startedOther settings you can make Changing TV channels Using the built-in TV tunerGetting started Making your first recording Playing back your recordingNicam a Nicam B Basic playbackChanging audio channels NicamTo stop playback, press Stop Press STANDBY/ON to switch onPlaying DVD discs Press OPEN/CLOSE to open the disc tray Load a discPlaying Video CD/Super VCDs Playing CDs and WMA/MP3 discsStop display Using the Home MenuDisplaying disc information on- screen Recording display Play displayGetting started Introduction Using the Disc Navigator to browse the contents of a discPlayback Playback ChapterSelect ‘Play’ from the menu options Using the Disc Navigator with recordable discsPlayback Changing the thumbnail picture for a titleScan Scan 2 Scan Navigating discsScanning discs Scan 1 Scan 2 Scan 3 ScanPress Frame advance/frame reversePlaying in slow motion Slow 1/2Play Mode Playback Play Mode menuSearch Mode Repeat play RepeatStart Program Play Starts playback of a saved program list Program playOther Program play functions Repeat to build up a program listClear Displaying and switching subtitlesSwitching DVD soundtracks To switch the camera angle, press Angle Playback Switching audio channelsSwitching camera angles To display/switch the audio channel, press Audio repeatedlyRecording time and picture quality RecordingRecording Chapter About DVD recordingRecording equipment and copyright Setting the picture quality/recording timeRecording Restrictions on video recording Use the Audio button to select the audio channel to record Setting a timer recordingRecording Basic recording from the TV Load a recordable discSet the TV channel and recording quality Easy Timer RecordingPress Easy Timer RecordingPress Enter to set the start time Standard timer recordingPress Timer REC to display the Timer Recording screen Current time Recording start timeTo exit the timer recording screen, press Home Menu Timer recording using the G-Code programming systemEnter the timer recording settings COD E Code programming with the power offExtending a timer recording in progress Programming a new end time Canceling and stopping a timer recording in progressMoving the end time by 30-minute blocks Simultaneous recording and playback Recording Timer recording FAQYou can’t enter a timer program if the clock isn’t set Automatic recording from a satellite tuner Set up the recorderPress REC when you’re ready to start recording Recording Recording from an external componentFinalizing a disc Playing your recordings on other DVD playersInitializing a DVD-RW disc Press Home Menu and select ‘Disc Setup’ Select ‘Finalize’How to change the recorder’s setting Press Home Menu and select ‘Disc Setup’ Select ‘Initialize’Disc Navigator screen EditingEditing Chapter Disc Navigator menu options Playlist / Original indicatorEditing Title Name Ttl Name Editing Editing VR mode Original and Video mode contentPlay EraseL 5 £ Using the remote key shortcuts to input a nameChapter Edit Chpt Edit I 4 î ï ì í ¡Title Inserting chapter markers into a titleErase Section Erase Sec Select ‘Erase Sec’ from the Disc Navigator menu options UseUndo You can’t undo a Lock commandLock / Unlock Erase AllPress Enter after selecting each character Creating and editing a VR mode Play ListYou can give titles new names of up to 64 characters long Input a name on Original title to put into the Play List CreatePress Enter to add the title DivideMove CombineSelect ‘Undo’ from the Disc Navigator Play List menu options This command erases all the titles from the Play ListDisc History Chapter Using the Disc HistoryDisc History Reloading files from a disc PhotoViewerPhotoViewer Chapter Playing a slideshowRotating the screen PhotoViewerZooming the screen Input Disc Name Disc Setup menuDisc Setup menu Chapter Basic settingsFinalize Disc Setup menuInitialize settings Finalize settingsChoosing a preset Video/Audio Adjust menuVideo/Audio Adjust menu Chapter Setting the picture quality for TV and external inputsSelect the picture quality setting you want to adjust Video/Audio Adjust menuSetting the picture quality for disc playback Audio DRC Clock Setting Initial Setup menuInitial Setup menu Chapter Using the Initial Setup menuFront Panel Display Initial Setup menuInput Line System On Screen DisplayAuto Channel Setting Auto Scan Tuner settingsPower Save Setup Navigator Remote Control SetChannel Swapping Manual CH SettingInput Colour System Video In / Out settingsCode CH Setting PAL Component Video OutNtsc on PAL TV PAL SecamAudio Out settings Initial Setup menu Audio In settingsMpeg Out Dolby Digital Out96kHz PCM Out DTS OutSubtitle Language Initial Setup menu Language settingsOSD Language Audio LanguageSelecting ‘Other’ languages Recording settingsDVD Menu Language Subtitle DisplayPlayback settings Parental Lock Parental Lock Set PasswordStill Picture Seamless PlaybackParental Lock Country Code Parental Lock Change PasswordParental Lock Change Level Press Enter to set the new Country code Angle IndicatorAdditional information Resetting the recorderSetting up the remote to control your Using the TV remote control buttonsAdditional information Screen sizes and disc formats General Additional information TroubleshootingAdditional information What kind of discs can I use for recording? Frequently asked questions Country, Country code, Country code letter Additional information Language code list Country code list Language Language code letter, Language codeRepairing disc This content is copy protectedAudio will conform to the Bilingual Recording setting Operation stopped due to power failureStoring discs Cleaning the pickup lensHandling discs Damaged discsMoving the recorder Hints on installationAdditional information Condensation Manual recording modesAdditional information Glossary PureCinema PCM Pulse Code ModulationPBC PlayBack Control Video CD/Super VCD only Progressive scan videoInput/Output Additional information SpecificationsTimer TunerSupplied accessories VRB1336-A Pioneer Corporation