Pioneer DV-K302CD, DVD-V630 operating instructions Rear Panel

Page 13

Rear Panel

1

2 3

4 5 6 7

8 9

0

-

CONTROL

IN

 

 

Y

 

 

 

COMPONENT

 

 

 

VIDEO OUT

 

VIDEO OUT S-VIDEO OUT

VIDEO

PB

 

TV SYSTEM

 

 

PAL

OUT

 

 

SELECT

 

 

NTSC AUTO

 

 

 

 

 

PR

 

 

 

AUDIO OUT (2CH)

 

 

1

2

DIGITAL OUT

 

 

 

OPT.

 

L

 

 

 

ATTENUATOR

 

 

 

OFF

 

 

 

ON

 

 

 

R

 

AUDIO OUT (5.1CH)

FRONT SURROUND

LCENTER

RSUB

WOOFER

AC IN

NAMES AND FUNCTIONS

1DIGITAL OUT jacks (coaxial, optical (OPT.)) Use to output the digital audio signal recorded on discs. You can output the digital signal via either coaxial or optical output jack to an AV amplifier or receiver (page 18).

6VIDEO OUT SELECT switch

Use to set which output is used to output the video signals. Select either video/S-video or component video signal output depending on the connections you make (page 20).

2CONTROL IN jack

Use to connect this player to another component bearing the Pioneer ë mark. This lets you control this unit as though it were a component in a system. Player operations are then performed by pointing the remote control at the component that the player is connected to (page 21).

3TV SYSTEM switch

Use to change the TV signal mode to either PAL or NTSC according to the type of TV and disc to be used. When the switch is in the AUTO position, the player outputs the format on the disc as is

(page 21). (The TV SYSTEM switch is not present on DVD-V630.)

4VIDEO OUT jack

Connect to the video input on a TV or monitor or AV amplifier or receiver with video input capability. When using this jack, be sure to set VIDEO OUT SELECT to the left position (page 20).

5S-VIDEO OUT jack

If your TV or monitor has an S-video input, clear picture reproduction is possible by connecting the player to your TV or monitor via the S-video jack. When using this jack, be sure to set VIDEO OUT SELECT to the left position (page 20).

7COMPONENT VIDEO OUT jacks

If your projection monitor, projector or similar component has component video inputs, you can produce a higher quality picture on your projection monitor or projector by connecting to the component video outputs on this unit. When using these jacks, be sure to set VIDEO OUT SELECT to the right position (page 20).

8ATTENUATOR switch

Usually set to OFF. Switch it ON if the sound is distorted when enjoying Karaoke (page 37).

9AUDIO OUT (2 CH) jacks

Use to output two-channel audio (analog) to the audio stereo inputs on a TV or stereo amplifier. If you are connecting to a receiver that has both digital and analog input jacks for DVD player connection, it may be beneficial to make both connections (page 19).

0AUDIO OUT (5.1 CH) jacks

Use to output 6 discrete audio channels of decoded digital audio to a receiver or amplifier with discrete audio inputs (page 19).

-AC IN power cord connection terminal Use to connect the power cord to the wall outlet (page 16).

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents DV-K302CD Important Safety Instructions Information to User Important Notice For U.S. modelFor Canadian model Pour le modèle CanadienWhat is Super VCD? Features of This PlayerYou can enjoy the unique operation of a 3-disc changer Wide range of DVD viewing options Easy setup and adjustment using on-screen menusEnergy-saving design Differences in Disc Composition How to Proceed in This ManualTable of Contents Checking Accessories Before UsingPreparing the Remote Control Inserting batteries into the remote controlBefore Using Remote control operationFront Panel Names and Functions Display Window Rear Panel Remote Control Pause button £ Search Mode buttonPROGRAMbutton = Repeat buttonConnection Guide Connecting Your DVD PlayerMaking Connections Home Theater Component ConnectionsDigital Audio Connections Audio ConnectionsDigital OUT Coaxial Digital OUT OpticalAnalog Audio Connection When making 5.1 channel analog audio connectionsChannel Audio OUT Channels are connected correctly on bothVideo OUT Video ConnectionsComponent Video OUT About MOD. Modulation PAL TV System switch DV-K302CD onlyUsing the Setup Navigator Setting Up the PlayerSettings Setting the TV screen sizeSettings Widescreen Standard EnglishChannel To coordinate your speaker system for 5.1 channel outputNot Connected Not PresentConfirming the settings Setting compatibility with 96 kHz outputTo exit the Setup screen To change other player settings in the Setup Screen menusPlayer Getting StartedPlaying DVDs, Super VCDs, Video CDs and CDs DVD/Super VCD/Video CD/CDImproving Picture Quality When a menu screen is displayedTo navigate a menu screen To play Super VCDs/Video CDs withoutSkipping back to the previous chapter track Advancing to the next chapter trackFast forward scanning Fast reverse scanningResuming playback from where Stopping Playback and Switching Power OffYou stopped -- DVD/Video CD Press the cursor button 3 to enter the setting options Video SettingsUse the cursor buttons 2/3 to select the menu you want Press the cursor button to enter the menuSetup screen closes Video SettingsSettings 2 Channel Use the cursor buttons 2/3 to select the speaker Setting Your Speaker System for Multichannel Audio PlaybackAbout source audio output DTS Out Dolby Digital OutKHz PCM Out Mpeg OutSettings 43 Letter Box Pan & Scan Wide Setting the TV Screen SizeDifferences in screen sizes and DVD/Super VCD formats Setting the position of the on-screen display Expert Adjusting the OSD On-Screen DisplayAdjusting Audio and Video Settings Turning the on-screen display on Or off ExpertKaraoke Entertainment Karaoke OperationHowling Single Play FunctionEcho adjustment Adjusting to Create the Desired SoundChanging performance key Operation is possible with the micReserving a Desired Song One-Touch KaraokeTo continue program playback To confirm reservation detailsTo erase all program contents Making Settings on the Karaoke Setup MenuDisplaying the Karaoke Setup menu Setting the Vocal Partner feature Changing the setting of vocalsAdjusting the volume of the vocal Selecting the vocalChanging the settings Setting multiplexed or stereoChanging the key of the music Singing without the guide melodySelecting a Subtitle Language Multi-Language Subtitles Setting Language OptionsDVD Press Subtitle repeatedly during playbackSuper VCD Karaoke mode Super VCD Normal modeSetting the Language Options Changing the Audio Language Multi-Language Function DVDWhen Other is selected Preferences in the Setup Screen MenusSelecting an audio language preference Selecting a subtitle language preferenceSelecting a DVD menu language preference Expert Settings w/ Subtitle Language English OtherSelecting the language of forced Subtitles Off Assist SubtitleContent DVD/Super VCD/Video CD Adjusting the Dynamic Range of the Audio Soundtrack DVDAdvanced Functions Selecting Picture Quality Appropriate for ProgramViewing a still frame Still Frame/Slow Play/Frame Advance PlaybackSelecting the type of paused image to display Expert Viewing slow playbackChanging the type of direct search Press Search Mode repeatedly to select the type of searchPress Play Changing to Surround Turning the angle indicator onViewing from a Desired Camera Angle Multi-Angle Press Angle during playbackRepeat play of a chapter/track Repeat play of a specified sectionRepeat play of a title/disc Repeat play of all discsWhen a DVD with a set Parental Lock level is loaded Setting the Parental Lock LevelEntering the password Press Enter to set the new passwordChanging the password Setting the Parental Lock levelEnter your current password Press Enter to set the new levelMemorizing a Last Memory location to return to later Resuming playback from where Last Memory was pressedMemory DVD/Video CD To clear the Last Memory locationErasing the memorized settings When a disc that has memorized settings is loadedSettings are memorized for the disc currently playing Following 9 settings are memorizedAdvanced Functions Viewing Disc InformationSuper VCD Video CD with PBC disabled Resetting the Player to System SettingsChanging the Background Color of the Screen Expert CD/Video CDDisc Care Additional InformationFor Proper and Long Use of This Unit Language Input-code Language Code ListTroubleshooting Additional Information For Karaoke mode onlyDTS TermsMpeg PCM When moving the player Specifications
Top Page Image Contents