Pioneer DVD-204 instruction manual Using the same technique, make the following settings

Page 20

The player is now set such that when power is applied to it, it will automatically “wake up” on Title 1, Chapter 1.

Using the same technique, make the following settings:

Title	Play Mode	Single
Key Lock		OFF
Repeat	Mode	OFF
SERIAL	PORT	15 Pin
BAUD RATE		9600 bps
EXTEND	TERMINAL	Standard
SYNC OUT (DURING SQ)		OFF

This completes the setup for the Pioneer DVD player.

Press the SETUP button to exit the menu. The player is now ready for use. Complete the rest of the installation following the instructions in the DVD-204 / DVD-212 Manual

Created and issued April 21 2005

Museum Technology Source Inc. www.museumtech.com 800-729-6873

Image 20

Contents New with Version 2.03 On-Screen Programming Introduction Settings for Pioneer 7400 DVD Player Pioneer DVD SetupReviewing the DVD Disc Settings for Pioneer 7200 DVD PlayerPreparing for Programming Configuring the computer used for programming Programming the DVD-204 /DVD-212Selecting Chapter, Frame, or Chapter Start/Frame End Programming the ButtonsProgramming the Idle or Attract Loop Main Menu againMain Menu Testing the Lamps and Buttons Options MenuList of Options Button 1 Lamp InversionButton 4 or Button 12 Reset Slave Delay Multiple Player InstallationsPC-9 Programming Cable Rear Panel Connections, DVD-204 and DVD-212 ON-SCREEN Programming Button 3 Plays Frames 3000 to Change this? Yes Button 3 plays Frames 5678 to Change this? Yes Museum Technology Source, Inc Master Player LDV-2 Splitter CableMuseum Technology Control Units with a Windows Based PC Trouble Shooting Addendum Setup Instructions Pioneer DVD-V5000 Player Using the same technique, make the following settings