Pioneer DVD-204 instruction manual Museum Technology Source, Inc

Page 15

is the Exit and Run command. The player will now revert to it's normal state, ready for use.

You may wish to program what the DVD does between plays. This is done on the main menu by pressing button 2 to bring up the Idle program. By fol- lowing the steps shown on-screen, you may have the video freeze on a still frame until a button is pushed, play from a start frame to an end frame over and over, or do nothing.

From the main menu, pressing button 4 will take you to the Option menu, which includes the Interruptability, slave delay, and button test func- tions. These are described earlier in this manual.

Issued:

February 20, 2002

Museum Technology Source, Inc.

Info@museumtech.com

www.museumtech.com

(800)729-6873 or (978)657-3898

Image 15

Contents New with Version 2.03 On-Screen Programming Introduction Pioneer DVD Setup Settings for Pioneer 7400 DVD PlayerSettings for Pioneer 7200 DVD Player Preparing for ProgrammingReviewing the DVD Disc Programming the DVD-204 /DVD-212 Configuring the computer used for programmingProgramming the Buttons Selecting Chapter, Frame, or Chapter Start/Frame EndMain Menu again Main MenuProgramming the Idle or Attract Loop Button 1 Lamp Inversion Testing the Lamps and ButtonsOptions Menu List of OptionsSlave Delay Multiple Player Installations Button 4 or Button 12 ResetPC-9 Programming Cable Rear Panel Connections, DVD-204 and DVD-212 ON-SCREEN Programming Button 3 Plays Frames 3000 to Change this? Yes Button 3 plays Frames 5678 to Change this? Yes Museum Technology Source, Inc LDV-2 Splitter Cable Master PlayerMuseum Technology Control Units with a Windows Based PC Trouble Shooting Addendum Setup Instructions Pioneer DVD-V5000 Player Using the same technique, make the following settings