Pioneer DVD-204 instruction manual PC-9 Programming Cable

Page 10

This completes the programming of the control unit. Unplug the Programming Cable from the back of the unit, and store it away for the next programming session. Connect the supplied LDV cable (3 pin round to 15 pin) from the player to the controller. At this point it is recommended that both the controller and the player have their power shut off for 10 seconds. When they are turned back on, the DVD-204 /DVD-212 will wait 45 seconds before sending any commands to the player. This is to ensure that the player has had time to spin up. During this time, the red “Program” light on the back of the controller will wink. When it goes out, the player will go to its Idle (or Attract) sequence, and the pushbuttons will be enabled. Note that the pushbuttons will only illuminate once the player is up to speed.

PC-9 Programming Cable

Player and Programming Cable Pinouts

Image 10

Contents New with Version 2.03 On-Screen Programming Introduction Settings for Pioneer 7400 DVD Player Pioneer DVD SetupPreparing for Programming Settings for Pioneer 7200 DVD PlayerReviewing the DVD Disc Configuring the computer used for programming Programming the DVD-204 /DVD-212Selecting Chapter, Frame, or Chapter Start/Frame End Programming the Buttons Main Menu Main Menu again Programming the Idle or Attract Loop List of Options Testing the Lamps and ButtonsOptions Menu Button 1 Lamp InversionButton 4 or Button 12 Reset Slave Delay Multiple Player InstallationsPC-9 Programming Cable Rear Panel Connections, DVD-204 and DVD-212 ON-SCREEN Programming Button 3 Plays Frames 3000 to Change this? Yes Button 3 plays Frames 5678 to Change this? Yes Museum Technology Source, Inc Master Player LDV-2 Splitter CableMuseum Technology Control Units with a Windows Based PC Trouble Shooting Addendum Setup Instructions Pioneer DVD-V5000 Player Using the same technique, make the following settings