Toshiba D-VR4XSU owner manual Error/Warning message list, General, Recording, Dubbing

Error/Warning message list

	ERROR/WARNING MESSAGE	CAUSE	POSSIBLE SOLUTIONS
General	System error.	The power was shut down without com-	Wait until the message disappears.
	Please wait.	pleting the termination process due to a
		power failure or disconnection of the AC
		cord plug. (Abnormal termination)
	System error.	The data restoration was completed.	Press ENTER, then the screen re-
	Disc might be failed.		turns to the normal display. The
	Press ENTER.		data may not be restored even if
			the restoration process is performed.
	Disc error.	A scratch or contamination was found on	Check the disc and reload it, or use
		the disc.	another disc for recording.
	Incorrect disc.	The disc cannot be identified.	Check the disc and load a proper
			disc.
Playback	Cannot playback.	A scratch or contamination was found on	Check the disc and reload it, or use
		the disc.	another disc for recording.
	Region code error.	A disc specified other than “Region 1” or	A disc specified other than “Region
		“Region ALL” was loaded.	1” or “Region ALL” cannot be played
			back.
Recording	Cannot record.	Recording was tried onto the disc which	Load a recordable disc.
		does not support recording.
		• Adding data was tried onto the disc re	Load another disc for recording.
		corded in the other unit.
		• Adding data was tried to the disc where
		PC data was recorded.
	Cannot record.	Disc erase-protection is applied.	Select “Off” to cancel the disc
	Disc protected.		protection from Setup Menu (DISC).
			Or slide the protect switch to off on
			the DVD-RAM cartridge itself.
	Cannot record.	Recording was tried onto the finalized	Undo finalization or load another
	Disc finalized.	disc.	disc for recording.
	Data is being written to the	The recording termination is processing.	Wait until the process is completed.
	disc.
	No space on the disc.	Disc became full during recording.	Erase unnecessary titles or load
			another disc and restart recording.
	Cannot record, exceeds	99 titles were recorded on the disc.	Erase unnecessary titles or load
	limited number of titles.		another disc.
	Cannot record.	Recording was attempted on a copy	You cannot record a copy protected
	Protected image.	protected video.	video.
	The operation cannot be	An invalid key pressed during timer re-	Wait until the timer recording is com-
	executed during timer	cording standby and recording.	plete.
	recording standby and
	recording.
	Cancel T-REC standby after	Timer recording is standing by.	Cancel the timer recording standby
	executing this operation.		mode.
Dubbing	Unable to shift during	• A copy protected tape is used	Load another video tape or disc for
	duplication process.	• Disc protection is set.	recording and restart.
	Duplication aborted.
	Copying interrupted.	The video tape or disc became full during	Load another video tape or disc for
		dubbing.	recording and restart.

Additional information

NOTE: Any error/warning message other than those above might appear. Take measures against such a mes- sage by seeing the possible solutions above.

87

2H5-01 P82-87 87 7/25/05, 23:23