Toshiba D-VR7KC2 owner manual 102 EN

Page 102
There is no sound or the sound is distorted.
Setup menu cannot be called up.
There is no picture.
Picture noise appears.
V
C The cassette tape does not play back.
R The tape ejected after you press [REC I].
The remote control does not function.
The motor rotates even when playback / recording is stopped.
Symptom
The disc tray does not open when you press [OPEN/CLOSE A].
“Repairing” appears on the TV screen.
Repairing
In a case you intend to cancel the repairing process.
Do you want to cancel a repairing process ? When selecting “Yes”, the disc may not be usable.
Yes
No
Repairing
No image from HDMI connection.

D V D

TROUBLESHOOTING

Remedy

•It may take a few seconds for the disc tray to open after you have recorded or edited a disc. This is because the unit is adding disc data to the disc.

•If there is a power failure or unplugging during recording, finalizing, formatting or editing (even after “Repairing” disappears), a repairing process will begin automatically just after turning the unit on again. It may take several minutes up to about several hours.

•If you intend to cancel the repairing process, press [AOPEN/CLOSE] on the front panel, then select “Yes” and press [ENTER]. After that, press [OPEN/CLOSE A] to take out the disc. The disc canceled during the repairing process MAY NOT work.

•Check the HDMI connection. (Check the status of the HDMI related indications.)

•Check whether the connected monitor device or other device supports HDCP. (This unit will not output a video signal unless the other device supports HDCP.)

•Check the setting of HDMI.

•Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device.

•If the unit is connected to the unauthorized display device with an HDMI cable, the audio/video signal may not be output when playing back a commercial DVD-video.

•The HDMI sound is not output when “HDMI Audio” is set to “OFF”.

•Check the RCA audio cable connection. If you are using HDMI-DVI conversion cable, you must connect the RCA audio cable, too.

•Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device.

•Setup menus cannot be called up during DVD recording and playback.

•If you connect the cable to S-VIDEO OUT/ COMPONENT VIDEO OUT / HDMI OUT jack, connect it to AUDIO / VIDEO OUT jack instead.

•Head cleaning for VCR may be necessary. Refer to “Auto head cleaning” (page 5).

•Adjust tracking control for better picture by pressing [CH / ] while you are playing back a cassette tape.

•No cassette tape is inserted.

•Make sure the cassette tape has an erase-protection tab when you record to a cassette tape. If needed, cover the hole with cellophane tape.

•Check if a cassette tape is in this unit.

•The motor may rotate for the duration of approximately 5 minutes for efficient operation. This is not a malfunction.

102 EN

E9PG0CD_DVR7KC2_EN_v1.indd 102

2009/07/23 14:40:31

Page 101 Page 103
Image 102
Page 101 Page 103
Contents 1VMN27813 / E9PG0CD Function SetupOwner’s Record PlaybackPrecautions Symbol for Class ll Double InsulationAdditional Safety Instructions To Avoid the Hazards of Electrical Shock and Fire PrecautionsAvoid a place with drastic temperature changes Location and HandlingIR Signal Check Installation LocationSupplied Accessories Dew Condensation WarningCleaning Discs Maintenance ServicingCleaning the Cabinet Cleaning the Disc Lens Disc HandlingContents Contents Features Features Unplayable Discs Color SystemsRegion Codes Rear Panel Functional OverviewFront Panel Introduction ConnectionsFunctional Overview Installing the Batteries in the Remote ControlUsing a Remote Control Open the cover Insert batteriesUsing a Remote Control cont’d Setup buttonThevcr / DVD Recorder Switching File Name Information On-Screen Display / MenuDisc Information/Menu Title Name Information MP3/WMA Tag InformationTitle name information Guide to ON-SCREEN Displays and MenusOn-Screen Display / Menu cont’d File name informationMain Menu Display Message This is a new Power Save ECO featureFront Panel Display Guide Current status of the unitOverview ConnectionAntenna Connection Required Supplied cables used in this connection are as followsConnecting to a TV Using Audio / Video Out Jacks ConnectionSupplied cables used in this connection are as follows Connecting to a TV Using the S-Video Out JackConnecting to a TV Using Component Video Out Jacks RF coaxial cable x RCA audio cable L/R xConnecting to a TV with an Hdmi Compatible Port Hdmi Video Resolution and Actual Output SignalsCopyright protection system After making the connection as described above Connecting to a Cable / Satellite BoxWith this setup Make sure to select the appropriate input type byConnecting to a TV without Audio / Video Jacks Digital Audio ConnectionNo supplied cables are used in these connections Setting in the Setup Menu Actual Audio Output To set up Dolby Digital, refer to pages 85, 87Multi Channel Digital Audio Setting Dolby Digital Setting DTS SettingPress Enter to start Channel Initial SettingProceed to in Manual Clock Setting on Press Enter to activate ClockChannel Setting When scanning is over, press Setup to exitAuto Channel Scan Adding/Deleting Channels Channel SettingPress Setup to exit Use K / L to select Manual ChannelPress Setup to exit and turn off Setting the ClockAuto Clock Setting Manual Auto Clock SettingSetting the Clock Daylight Saving TimeUse K / L to select TV Audio Select, then press Enter Selecting TV AudioEnter SAP secondary audio programFormatting a Disc Choosing the Recording Format of a Brand-New DVD-RWReformatting a Disc Manually VR mode DVD-RWFormatting a Disc Use K / L to select Yes, then press EnterSetting a Disc to Protect To cancel the disc protectDisc will be protected Playingthe Discs in Other DVD Players Auto FinalizingUse K / L to select Finalize, then press Enter Playing the Discs in Other DVD PlayersFinalizing a Disc Finalizing is completedTo cancel finalizing DVD-RW only Finalizing a Disc cont’dRestrictions on Recording Recording ModeInformation on DVD Recording VideoPress Setup to exit Settings for a RecordingSetting for Auto Chapter Make Recording CompatibleRecording Audio Select XP Settings for a RecordingSetting Aspect Ratio for Video Mode RecordingIt may take awhile to load Disc completely Press I/y ON/STANDBYPress OPEN/CLOSE a to close the disc tray Instructions continue on the nextPress Stop C to stop recording Basic Recording & ONE-TOUCH Timer RecordingPress REC I to start recording Will be displayed for 5 secondsTimer Recording Use K / L to enter the date, thenPress B Press Enter when all items are entered Timer RecordingUse K / L to select a recording mode Press Timer SET to set a timer programmingTo stop the timer recording in progress Hints for Timer Recording Priority of Overlapped SettingsExternal device Settings for AN External DeviceConnection to an External Device Supplied cables used in this connection are as followsSettings for AN External Device Recording from an External DeviceUse K / L to select Dubbing General Setting menu will appearDVD/VCR Dubbing Use K / L to select Recording, then press EnterVCR to DVD DVD to VCR DVD/VCR DubbingPress Stop C to stop the recording For DVD to VCR duplicationStructure of Disc Contents Information on PlaybackDirect Playback Refer to Using the Title/Disc Menu onBasic Playback Press Stop C once to stop playback temporarilyTitle, then press Enter Playback from the Title ListPress DVD Use K / L to select Play FromBasic Playback Follow steps 1 to 2 in Direct Playback onWhen selecting file Playing Back a DivXPlaying Back a DivX cont’d Press DVD first During playback, press Pause F Using the Title/Disc MenuPause Playback will be paused and sound will be mutedFast Forward / Fast Reverse Playback Special PlaybackResume Playback 40x REV 20x REVStep by Step Playback Special PlaybackRapid Playback Slow Forward / Slow Reverse PlaybackPress DVD first During playback, press Display or Zoom Marker SettingZoom Use / B to select to display the selection menuWhile viewing a TV broadcast via this unit, press Time Slip Chasing Playback during RecordingDuring recording, press Play B This unit start to record the TV broadcastChapter Simultaneous Playback and RecordingSelected title playback will start To move to for chapter, press BSearch Using Skip j / SkipUsing Display Title/Chapter SearchSearch Time SearchAudio CD Repeat Playback Random PlaybackREPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE Show Program Playback5Press Play B Switching Subtitles Switching Audio SoundtrackSwitching Virtual Surround System Switching Camera Angles Selecting the Format of Audio and VideoReducing Block Noise Use K / L to select Black Level, then press Enter Adjusting Black LevelYour setting will be activated Use K / L to select OFF or ON, then press EnterInformation on Disc Editing Guide to a Title ListDeleting Titles After the disc is fully recordedDeleting Titles Stop mode, press TOP MenuOriginal CREATING/DELETING PlaylistAdding Titles to a Playlist Use K / L to select Add To Playlist, then press EnterErasing All Playlist Press DVD Press SetupCREATING/DELETING Playlist Use K / L to select Yes, then pressTo enter a title name, follow Editing DiscsPutting Names on Titles Stop mode, press TOP MenuEditing Discs Putting Names on Titles cont’dGuide to Edit Title Name Press Return Setting Chapter MarksUse Skip H / G Press Return again and then Return or Stop C to exitUse Skip H or Skip G to decide the chapter to be hidden Hiding ChaptersUse K / L to select Edit, then press Enter Title, then press EnterVR mode DVD-RW playlist Deleting a Part of a TitleDeleting a Part of a Title cont’d Use K / L to select Delete then press EnterPress Return and then Return or Stop C to exit Dividing a Title Press DVD Stop mode, press TOP MenuUse K / L/s / B to select a desired title, then press Enter Combining Titles You can combine two titles into a single titleTwo titles will combine into a single title Setting or Releasing the Title Protection Setting or Clearing All Chapter Marks at Once Use K / L to select the desired interval, then press EnterIf you select OFF at , all the chapter marks are erased List of the Default Settings Setup Items highlight is the default ContentsList of the Default Settings ONAPR-OCT OFFUse K / L to select a desired item, then press Enter General SettingPlayback Press Stop C if you are playing back a discUse the Number buttons to enter the current password General SettingParental Lock Default OFF Playback cont’dAudio Out Subtitle Language Default OFF Disc Menu Language Default EnglishAudio Language Default Original Angle Icon Default onFL Dimmer Default Bright OSD Language Default EnglishScreen Saver Default 10 minutes DisplayVideo Progressive Default OFFTV Aspect Default 169 Wide Selected itemDivX VOD DivX Subtitle Default OFFDivX Set the DivX subtitleFormat Default RGB HdmiRGB Range Default Normal Hdmi Audio Default onSet to OFF when the Hdmi sound is not output Hdmi cont’dReset All Select Yes using K / L , then press EnterReset the setting to default Setup VCR Function Others VCR FunctionsInformation on VCR Functions Using REC I or Stop C One-touch Timer Recording OTRYou cannot pause the one-touch timer recording VCR FunctionsOther Operations Troubleshooting Symptom RemedyTroubleshooting 102 EN Frequently Asked Questions Can I record to CD-RW/-R?Pages 23 Language Code Language CodeGlossary Recording SpecificationsGeneral Input / OutputLimited Warranty Lplwhg 2QH  HDU DUUDQW\ RQ 3DUWV DQG /DERXULimited Warranty $UELWUDWLRQ DQG Lvsxwh 5HVROXWLRQMemo
Top Page Image Contents