Toshiba D-VR7KC2 Connecting to a TV with an Hdmi Compatible Port, Copyright protection system

Page 22

CONNECTION

Connecting to a TV with an HDMI™ Compatible Port

•HDMI outputs the video / audio signals without converting to analog signals.

•No audio connection is required.

HDMI cable

HDMI IN

 

rear of this unit

ANT. IN

This connection is for

VHF / UHF

TV loop through only

antenna

OUT

RF coaxial cable

Do not tilt the connector when inserting it into the HDMI jack, and make sure the

shapes of the jack and the connector are matched.

IN

ANTENNA

RF coaxial cable

or

 

Supplied cables used in this connection are as follows:

• RF coaxial cable x 1

Please purchase the rest of the necessary cables at your local store.

cable TV company

HDMI Video Resolution and Actual Output Signals

Press [HDMI] to select the HDMI video resolution. The video resolution mode changes as follows every time [HDMI] is pressed.

Front Panel Display Video Output Signal

480 Progressive

Press [HDMI]

720 Progressive

Press [HDMI]

1080 interlaced

Press [HDMI]

1080 Progressive

Press [HDMI]

Copyright protection system

To play back the digital video images of a DVD via an HDMI connection, it is necessary that both the player and the display device (or an AV amplifier) support a copyright protection system called HDCP (high-bandwidth digital content protection system). HDCP is copy protection technology that comprises data encryption and authentication of the connected AV device. This unit supports HDCP. Please read the operating instructions of your display device (or AV amplifier) for more information.

*HDMI: High Definition Multimedia Interface

• The HDMI mode that is not supported by display device will be skipped.

Note

• Some devices with an HDMI input may not operate properly with this unit.

• When using an HDCP-incompatible display device, the image will not be viewed properly.

• Among the devices that support HDMI, some devices can control other devices via the HDMI connector; however, this unit cannot be

controlled by another device via the HDMI connector.

• The audio signals from the HDMI connector (including the sampling frequency, the number of channels and bit length) may be limited

by the device that is connected.

• Among the monitors that support HDMI, some do not support audio output (for example, projectors). In connections with device such as

this unit, audio signals are not output from the HDMI output connector.

• When this unit’s HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI converter cable, the

signals are output in digital RGB.

• When the power failure occurs, or when you unplug the unit, some problems in the HDMI setting might occur. Please check and set the

HDMI setting again.

• HDMI video resolution cannot be changed when the unit is in VCR mode.

22 EN

E9PG0CD_DVR7KC2_EN_v1.indd 22

2009/07/23 14:37:52

Page 21 Page 23
Image 22
Page 21 Page 23
Contents 1VMN27813 / E9PG0CD Function SetupOwner’s Record PlaybackSymbol for Class ll Double Insulation PrecautionsAdditional Safety Instructions To Avoid the Hazards of Electrical Shock and Fire PrecautionsAvoid a place with drastic temperature changes Location and HandlingIR Signal Check Installation LocationSupplied Accessories Dew Condensation WarningCleaning Discs Maintenance ServicingCleaning the Cabinet Cleaning the Disc Lens Disc HandlingContents Contents Features Features Color Systems Unplayable DiscsRegion Codes Rear Panel Functional OverviewFront Panel Introduction ConnectionsFunctional Overview Installing the Batteries in the Remote ControlUsing a Remote Control Open the cover Insert batteriesUsing a Remote Control cont’d Setup buttonThevcr / DVD Recorder Switching File Name Information On-Screen Display / MenuDisc Information/Menu Title Name Information MP3/WMA Tag InformationTitle name information Guide to ON-SCREEN Displays and MenusOn-Screen Display / Menu cont’d File name informationMain Menu Display Message This is a new Power Save ECO featureFront Panel Display Guide Current status of the unitOverview ConnectionAntenna Connection Required Supplied cables used in this connection are as followsConnecting to a TV Using Audio / Video Out Jacks ConnectionSupplied cables used in this connection are as follows Connecting to a TV Using the S-Video Out JackConnecting to a TV Using Component Video Out Jacks RF coaxial cable x RCA audio cable L/R xHdmi Video Resolution and Actual Output Signals Connecting to a TV with an Hdmi Compatible PortCopyright protection system After making the connection as described above Connecting to a Cable / Satellite BoxWith this setup Make sure to select the appropriate input type byDigital Audio Connection Connecting to a TV without Audio / Video JacksNo supplied cables are used in these connections Setting in the Setup Menu Actual Audio Output To set up Dolby Digital, refer to pages 85, 87Multi Channel Digital Audio Setting Dolby Digital Setting DTS SettingPress Enter to start Channel Initial SettingProceed to in Manual Clock Setting on Press Enter to activate ClockWhen scanning is over, press Setup to exit Channel SettingAuto Channel Scan Adding/Deleting Channels Channel SettingPress Setup to exit Use K / L to select Manual ChannelPress Setup to exit and turn off Setting the ClockAuto Clock Setting Manual Auto Clock SettingSetting the Clock Daylight Saving TimeUse K / L to select TV Audio Select, then press Enter Selecting TV AudioEnter SAP secondary audio programFormatting a Disc Choosing the Recording Format of a Brand-New DVD-RWReformatting a Disc Manually VR mode DVD-RWFormatting a Disc Use K / L to select Yes, then press EnterTo cancel the disc protect Setting a Disc to ProtectDisc will be protected Playingthe Discs in Other DVD Players Auto FinalizingUse K / L to select Finalize, then press Enter Playing the Discs in Other DVD PlayersFinalizing a Disc Finalizing is completedTo cancel finalizing DVD-RW only Finalizing a Disc cont’dRestrictions on Recording Recording ModeInformation on DVD Recording VideoPress Setup to exit Settings for a RecordingSetting for Auto Chapter Make Recording CompatibleRecording Audio Select XP Settings for a RecordingSetting Aspect Ratio for Video Mode RecordingIt may take awhile to load Disc completely Press I/y ON/STANDBYPress OPEN/CLOSE a to close the disc tray Instructions continue on the nextPress Stop C to stop recording Basic Recording & ONE-TOUCH Timer RecordingPress REC I to start recording Will be displayed for 5 secondsUse K / L to enter the date, then Timer RecordingPress B Press Enter when all items are entered Timer RecordingUse K / L to select a recording mode Press Timer SET to set a timer programmingTo stop the timer recording in progress Hints for Timer Recording Priority of Overlapped SettingsExternal device Settings for AN External DeviceConnection to an External Device Supplied cables used in this connection are as followsSettings for AN External Device Recording from an External DeviceUse K / L to select Dubbing General Setting menu will appearDVD/VCR Dubbing Use K / L to select Recording, then press EnterVCR to DVD DVD to VCR DVD/VCR DubbingPress Stop C to stop the recording For DVD to VCR duplicationStructure of Disc Contents Information on PlaybackDirect Playback Refer to Using the Title/Disc Menu onBasic Playback Press Stop C once to stop playback temporarilyTitle, then press Enter Playback from the Title ListPress DVD Use K / L to select Play FromBasic Playback Follow steps 1 to 2 in Direct Playback onWhen selecting file Playing Back a DivXPlaying Back a DivX cont’d Press DVD first During playback, press Pause F Using the Title/Disc MenuPause Playback will be paused and sound will be mutedFast Forward / Fast Reverse Playback Special PlaybackResume Playback 40x REV 20x REVStep by Step Playback Special PlaybackRapid Playback Slow Forward / Slow Reverse PlaybackPress DVD first During playback, press Display or Zoom Marker SettingZoom Use / B to select to display the selection menuWhile viewing a TV broadcast via this unit, press Time Slip Chasing Playback during RecordingDuring recording, press Play B This unit start to record the TV broadcastChapter Simultaneous Playback and RecordingSelected title playback will start To move to for chapter, press BSearch Using Skip j / SkipUsing Display Title/Chapter SearchTime Search SearchAudio CD Repeat Playback Random PlaybackProgram Playback REPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE Show5Press Play B Switching Subtitles Switching Audio SoundtrackSelecting the Format of Audio and Video Switching Virtual Surround System Switching Camera AnglesReducing Block Noise Use K / L to select Black Level, then press Enter Adjusting Black LevelYour setting will be activated Use K / L to select OFF or ON, then press EnterInformation on Disc Editing Guide to a Title ListDeleting Titles After the disc is fully recordedDeleting Titles Stop mode, press TOP MenuOriginal CREATING/DELETING PlaylistAdding Titles to a Playlist Use K / L to select Add To Playlist, then press EnterErasing All Playlist Press DVD Press SetupCREATING/DELETING Playlist Use K / L to select Yes, then pressTo enter a title name, follow Editing DiscsPutting Names on Titles Stop mode, press TOP MenuPutting Names on Titles cont’d Editing DiscsGuide to Edit Title Name Press Return Setting Chapter MarksUse Skip H / G Press Return again and then Return or Stop C to exitUse Skip H or Skip G to decide the chapter to be hidden Hiding ChaptersUse K / L to select Edit, then press Enter Title, then press EnterVR mode DVD-RW playlist Deleting a Part of a TitleUse K / L to select Delete then press Enter Deleting a Part of a Title cont’dPress Return and then Return or Stop C to exit Press DVD Stop mode, press TOP Menu Dividing a TitleUse K / L/s / B to select a desired title, then press Enter You can combine two titles into a single title Combining TitlesTwo titles will combine into a single title Setting or Releasing the Title Protection Use K / L to select the desired interval, then press Enter Setting or Clearing All Chapter Marks at OnceIf you select OFF at , all the chapter marks are erased List of the Default Settings Setup Items highlight is the default ContentsList of the Default Settings ONAPR-OCT OFFUse K / L to select a desired item, then press Enter General SettingPlayback Press Stop C if you are playing back a discUse the Number buttons to enter the current password General SettingParental Lock Default OFF Playback cont’dAudio Out Subtitle Language Default OFF Disc Menu Language Default EnglishAudio Language Default Original Angle Icon Default onFL Dimmer Default Bright OSD Language Default EnglishScreen Saver Default 10 minutes DisplayVideo Progressive Default OFFTV Aspect Default 169 Wide Selected itemDivX VOD DivX Subtitle Default OFFDivX Set the DivX subtitleFormat Default RGB HdmiRGB Range Default Normal Hdmi Audio Default onSet to OFF when the Hdmi sound is not output Hdmi cont’dSelect Yes using K / L , then press Enter Reset AllReset the setting to default VCR Functions Setup VCR Function OthersInformation on VCR Functions Using REC I or Stop C One-touch Timer Recording OTRYou cannot pause the one-touch timer recording VCR FunctionsOther Operations Troubleshooting Symptom RemedyTroubleshooting 102 EN Can I record to CD-RW/-R? Frequently Asked QuestionsPages 23 Language Code Language CodeGlossary Recording SpecificationsGeneral Input / OutputLimited Warranty Lplwhg 2QH  HDU DUUDQW\ RQ 3DUWV DQG /DERXULimited Warranty $UELWUDWLRQ DQG Lvsxwh 5HVROXWLRQMemo
Top Page Image Contents