Toshiba D-VR7KC2 owner manual To stop the timer recording in progress

TIMER RECORDING

To stop the timer recording in progress

1)Press [STOP C ] on the remote control.

2)Confirmation message will appear. Select “Yes”, then press [ENTER].

•To stop the timer recording immediately, press [STOP C] on the unit.

Checking, canceling, or correcting the timer programming information

1)Press [TIMER SET].

2)Press [TIMER PROG.].

3)Check the information on the list you want to edit.

Timer Programming

JAN/ 2/09 1:00 AM 125-01 SP
SP (1:00)			THU JAN/01 10:00AM
Date	Start		End	CH
JAN/02	1:00AM	2:00AM		10
	New Program
				1/1

4-A) To delete the timer program:

1 Use [K / L] to select the program you want to delete, then press [ENTER].

2 Use [K / L] to select “Delete”, then press [ENTER].

Selection menu will appear.

3 Use [K / L] to select “Yes”, then press [ENTER].

4-B) To correct the timer program:

1 Use [K / L] to select the program you want to correct, then press [ENTER].

2 Use [K / L] to select “Program Change”, then press [ENTER].

3 Correct the timer program by using [K/ L/ {/ B], then press [ENTER].

5)Press [TIMER PROG.] to exit.

6)Press [TIMER SET] to return to the timer standby mode.

If the timer program did not complete correctly, the error number appears in the timer programming list.

				Timer Programming
								THU JAN/01 10:00AM
					Date	Start		End	CH
			E40		JAN/02	1:00AM	2:00AM		10
						New Program
									1/1
Each error number means:
	E1-22	Recording error other					E40		Some portion has
	E37-39	than below							not been recorded
									because of program
	E23-24	Unrecordable disc							overlapping.
									Recording did not
	E25-28	Copy prohibited program
									start at the start time.
	E29	Disc protected					E41		Power failed
	E30	Disc full					E42		No disc when recording
	E31-32	Already 99 titles					E43		Already 49 titles
		recorded							recorded
	E33	Already 999 chapters					E44		Already 254 chapters
		recorded							recorded
	E34	No space for Control					E45		Copy prohibited
		information							program
	E35	PCA full *1					E46		It is impossible to
									record additionally
	E36	Already finalized							on a disc recorded
									by other units
		video format disc
									when setting
									“Make Recording
									Compatible” to “OFF”.

•A program with the error number is grayed in the timer programming list.

•Once the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared.

*1 PCA is a disc's space reserved for recording test.

Disc Introduction Connections Basic Setup Management Recording Playback Editing

Note

•Press [TIMER PROG.] to check the timer recording in progress.

When the timer recording is proceeding, that program will be highlighted in red. In this case, you cannot select any other program.

EN 45

Function Setup VCR Function Others

E9PG0CD_DVR7KC2_EN_v1.indd 45

2009/07/23 14:38:47