Toshiba D-VR7KC2 owner manual Precautions, To Avoid the Hazards of Electrical Shock and Fire

Page 3

PRECAUTIONS

This Class B digital apparatus complies with Canadian ICES-003.

Disconnect the mains plug to shut off when find trouble or not in use. The mains plug shall remain readily operable.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

WARNING: Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire, or the like.

LASER SAFETY

This apparatus employs a laser. Only a qualified service person should remove the cover or attempt to service this apparatus, due to possible eye injury.

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

CAUTION: Visible and invisible laser radiation when open and interlock defeated. Do not stare into beam.

LOCATION: Inside, near the deck mechanism.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized copying, broadcasting, public performance and lending of discs are prohibited. This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death.

Disc

Introduction Connections Basic Setup Management

To Avoid the Hazards of Electrical Shock and Fire

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

Do not put your fingers or objects into the unit.

Location and Handling

Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration.

Avoid a place with drastic temperature changes.

Install the unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit. Depending on your external devices, noise or disturbance of the picture and/or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit.

Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.

Be sure to remove the disc and unplug the AC power cord from the outlet before carrying the unit.

EN 3

Recording Playback Editing Function Setup VCR Function Others

E9PG0CD_DVR7KC2_EN_v1.indd 3

2009/07/23 14:37:14

Image 3
Contents Playback Function SetupOwner’s Record 1VMN27813 / E9PG0CDPrecautions Symbol for Class ll Double InsulationAdditional Safety Instructions Location and Handling PrecautionsAvoid a place with drastic temperature changes To Avoid the Hazards of Electrical Shock and FireDew Condensation Warning Installation LocationSupplied Accessories IR Signal CheckCleaning the Disc Lens Disc Handling Maintenance ServicingCleaning the Cabinet Cleaning DiscsContents Contents Features Features Unplayable Discs Color SystemsRegion Codes Introduction Connections Functional OverviewFront Panel Rear PanelOpen the cover Insert batteries Installing the Batteries in the Remote ControlUsing a Remote Control Functional OverviewSetup button Using a Remote Control cont’dThevcr / DVD Recorder Switching MP3/WMA Tag Information On-Screen Display / MenuDisc Information/Menu Title Name Information File Name InformationFile name information Guide to ON-SCREEN Displays and MenusOn-Screen Display / Menu cont’d Title name informationMain Menu Current status of the unit This is a new Power Save ECO featureFront Panel Display Guide Display MessageSupplied cables used in this connection are as follows ConnectionAntenna Connection Required OverviewConnection Connecting to a TV Using Audio / Video Out JacksRF coaxial cable x RCA audio cable L/R x Connecting to a TV Using the S-Video Out JackConnecting to a TV Using Component Video Out Jacks Supplied cables used in this connection are as followsConnecting to a TV with an Hdmi Compatible Port Hdmi Video Resolution and Actual Output SignalsCopyright protection system Make sure to select the appropriate input type by Connecting to a Cable / Satellite BoxWith this setup After making the connection as described aboveConnecting to a TV without Audio / Video Jacks Digital Audio ConnectionNo supplied cables are used in these connections Dolby Digital Setting DTS Setting To set up Dolby Digital, refer to pages 85, 87Multi Channel Digital Audio Setting Setting in the Setup Menu Actual Audio OutputPress Enter to activate Clock Initial SettingProceed to in Manual Clock Setting on Press Enter to start ChannelChannel Setting When scanning is over, press Setup to exitAuto Channel Scan Use K / L to select Manual Channel Channel SettingPress Setup to exit Adding/Deleting ChannelsManual Auto Clock Setting Setting the ClockAuto Clock Setting Press Setup to exit and turn offDaylight Saving Time Setting the ClockSAP secondary audio program Selecting TV AudioEnter Use K / L to select TV Audio Select, then press EnterChoosing the Recording Format of a Brand-New DVD-RW Formatting a DiscUse K / L to select Yes, then press Enter VR mode DVD-RWFormatting a Disc Reformatting a Disc ManuallySetting a Disc to Protect To cancel the disc protectDisc will be protected Auto Finalizing Playingthe Discs in Other DVD PlayersFinalizing is completed Playing the Discs in Other DVD PlayersFinalizing a Disc Use K / L to select Finalize, then press EnterFinalizing a Disc cont’d To cancel finalizing DVD-RW onlyVideo Recording ModeInformation on DVD Recording Restrictions on RecordingMake Recording Compatible Settings for a RecordingSetting for Auto Chapter Press Setup to exitRecording Settings for a RecordingSetting Aspect Ratio for Video Mode Recording Audio Select XPInstructions continue on the next Press I/y ON/STANDBYPress OPEN/CLOSE a to close the disc tray It may take awhile to load Disc completelyWill be displayed for 5 seconds Basic Recording & ONE-TOUCH Timer RecordingPress REC I to start recording Press Stop C to stop recordingTimer Recording Use K / L to enter the date, thenPress B Press Timer SET to set a timer programming Timer RecordingUse K / L to select a recording mode Press Enter when all items are enteredTo stop the timer recording in progress Priority of Overlapped Settings Hints for Timer RecordingSupplied cables used in this connection are as follows Settings for AN External DeviceConnection to an External Device External deviceRecording from an External Device Settings for AN External DeviceUse K / L to select Recording, then press Enter General Setting menu will appearDVD/VCR Dubbing Use K / L to select DubbingFor DVD to VCR duplication DVD/VCR DubbingPress Stop C to stop the recording VCR to DVD DVD to VCRInformation on Playback Structure of Disc ContentsPress Stop C once to stop playback temporarily Refer to Using the Title/Disc Menu onBasic Playback Direct PlaybackUse K / L to select Play From Playback from the Title ListPress DVD Title, then press EnterFollow steps 1 to 2 in Direct Playback on Basic PlaybackPlaying Back a DivX When selecting filePlaying Back a DivX cont’d Playback will be paused and sound will be muted Using the Title/Disc MenuPause Press DVD first During playback, press Pause F40x REV 20x REV Special PlaybackResume Playback Fast Forward / Fast Reverse PlaybackSlow Forward / Slow Reverse Playback Special PlaybackRapid Playback Step by Step PlaybackUse / B to select to display the selection menu Marker SettingZoom Press DVD first During playback, press Display or ZoomThis unit start to record the TV broadcast Chasing Playback during RecordingDuring recording, press Play B While viewing a TV broadcast via this unit, press Time SlipTo move to for chapter, press B Simultaneous Playback and RecordingSelected title playback will start ChapterTitle/Chapter Search Using Skip j / SkipUsing Display SearchSearch Time SearchAudio CD Random Playback Repeat PlaybackREPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE Show Program Playback5Press Play B Switching Audio Soundtrack Switching SubtitlesSwitching Virtual Surround System Switching Camera Angles Selecting the Format of Audio and VideoReducing Block Noise Use K / L to select OFF or ON, then press Enter Adjusting Black LevelYour setting will be activated Use K / L to select Black Level, then press EnterGuide to a Title List Information on Disc EditingAfter the disc is fully recorded Deleting TitlesStop mode, press TOP Menu Deleting TitlesUse K / L to select Add To Playlist, then press Enter CREATING/DELETING PlaylistAdding Titles to a Playlist OriginalUse K / L to select Yes, then press Press DVD Press SetupCREATING/DELETING Playlist Erasing All PlaylistStop mode, press TOP Menu Editing DiscsPutting Names on Titles To enter a title name, followEditing Discs Putting Names on Titles cont’dGuide to Edit Title Name Press Return again and then Return or Stop C to exit Setting Chapter MarksUse Skip H / G Press ReturnTitle, then press Enter Hiding ChaptersUse K / L to select Edit, then press Enter Use Skip H or Skip G to decide the chapter to be hiddenDeleting a Part of a Title VR mode DVD-RW playlistDeleting a Part of a Title cont’d Use K / L to select Delete then press EnterPress Return and then Return or Stop C to exit Dividing a Title Press DVD Stop mode, press TOP MenuUse K / L/s / B to select a desired title, then press Enter Combining Titles You can combine two titles into a single titleTwo titles will combine into a single title Setting or Releasing the Title Protection Setting or Clearing All Chapter Marks at Once Use K / L to select the desired interval, then press EnterIf you select OFF at , all the chapter marks are erased Setup Items highlight is the default Contents List of the Default SettingsONAPR-OCT OFF List of the Default SettingsPress Stop C if you are playing back a disc General SettingPlayback Use K / L to select a desired item, then press EnterPlayback cont’d General SettingParental Lock Default OFF Use the Number buttons to enter the current passwordAudio Out Angle Icon Default on Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFDisplay OSD Language Default EnglishScreen Saver Default 10 minutes FL Dimmer Default BrightSelected item Progressive Default OFFTV Aspect Default 169 Wide VideoSet the DivX subtitle DivX Subtitle Default OFFDivX DivX VODHdmi Format Default RGBHdmi cont’d Hdmi Audio Default onSet to OFF when the Hdmi sound is not output RGB Range Default NormalReset All Select Yes using K / L , then press EnterReset the setting to default Setup VCR Function Others VCR FunctionsInformation on VCR Functions VCR Functions One-touch Timer Recording OTRYou cannot pause the one-touch timer recording Using REC I or Stop COther Operations Symptom Remedy TroubleshootingTroubleshooting 102 EN Frequently Asked Questions Can I record to CD-RW/-R?Pages 23 Language Code Language CodeGlossary Input / Output SpecificationsGeneral RecordingLplwhg 2QH  HDU DUUDQW\ RQ 3DUWV DQG /DERXU Limited Warranty$UELWUDWLRQ DQG Lvsxwh 5HVROXWLRQ Limited WarrantyMemo