Toshiba D-VR7KC2 owner manual Troubleshooting

Page 101

TROUBLESHOOTING

 

Symptom

Remedy

 

Timer recording is impossible.

• Press [TIMER SET] for timer standby mode.

 

 

 

 

The remote control does not function.

• Batteries are weak.

D

• There are obstacles between the remote control and the unit.

• The remote control is far from the unit.

V

• There are no batteries in the remote control.

D

• Check if the unit is turned on.

•

• The remote control is not pointed at the infrared sensor window on the unit.

• Press [DVD] or [VCR], whichever you need. Then, try again.

 

 

V

• Press [TIMER SET] to cancel the timer standby mode.

CThe unit does not operate properly. • When static electricity, etc., causes the unit to operate abnormally,

R

 

 

unplug the unit and then plug it in again.

 

 

Nothing appears on the front panel

• The front panel display goes off when the unit is on standby mode.

 

 

display when the unit is on standby

This is not a malfunction.

 

 

mode.

 

 

 

 

 

 

 

 

 

There is no picture.

• If the setup menu appears on the TV screen, press [RETURN] to exit.

 

• Check if the progressive scan mode is set correctly according to your TV

 

(page 92).

Picture noise appears.

• Clean the disc with a cleaning cloth.

Playback picture from the external

• If the picture output signal from the external devices passes through this

devices connected to this unit is

unit to get to your TV, the copy protection signal applied to some DVD could

distorted.

affect the picture quality. Disconnect the playback device in question and

 

connect it directly to your TV.

There is no sound.

• If you are using DIGITAL AUDIO OUT (COAXIAL) jack, check the setting in

 

“Audio Out” (page 89).

 

• Clean the disc with a cleaning cloth.

Sound is noisy.

• Clean the disc with a cleaning cloth.

The disc does not play back.

• No disc is inserted.

 

• A blank disc is inserted.

 

• The disc is upside down. Insert the disc with the labeled side facing up.

 

• The disc is not correctly inserted.

 

• The unit cannot play back certain discs (such as a CD-ROM) (pages 9-10).

 

• The region code on the DVD-video does not match the unit (page 10).

 

• Moisture has condensed inside the unit. Remove the disc and leave the

 

unit turned on for about 2 hours until the moisture evaporates (page 4).

 

• If the disc was recorded on another recorder, the unit cannot play back

 

the disc if it was not finalized.

DPlayback image freezes for a second. • During the playback of 2 layered disc, picture may freeze for a moment

V

when the 1st layer switches to the 2nd layer. This is not a malfunction.

DDiscs recorded on this unit cannot be • If you are using DVD-RW/-R or DVD+R, please ensure you finalized the

played back on other DVD players. disc after recording (pages 35-36).

The disc does not start playback from • Resume playback was activated (page 58). Press [STOP C] twice.

the beginning.

• You have inserted a disc whose title menu or DVD menu automatically

 

appears on the TV screen when it is first inserted.

The unit starts playing back the disc

• The DVD-video features an auto playback function.

automatically.

 

Some functions such as stop, search, • Depending on the disc, you may not be able to do some of the

or slow-motion playback cannot be

operations. Refer to the instruction manual supplied with the disc.

performed.

 

The language for the sound track

• The title does not have the multilingual audio tracks.

cannot be changed.

• The DVD-video prohibits the changing of the language for the sound

 

track.

The subtitle language cannot be

• Multilingual subtitle are not recorded on the DVD-video.

changed or turned off.

 

The angles cannot be changed.

• Multi-angles are not recorded on the DVD-video being played back.

 

• The angle-change operation is whenever possible as long as the disc

 

contains a multi-angle portion. Actual change will be performed when

 

the portion has come up.

 

• The DVD-video prohibits changing angles.

 

• Try changing the angle using the DVD-video’s menu.

Recording does not stop immediately

• It may take a few seconds for the unit to input disc data before

after you press [STOP C].

recording stops.

EN 101

Disc Introduction Connections Basic Setup Management Recording Playback Editing Function Setup VCR Function Others

E9PG0CD_DVR7KC2_EN_v1.indd 101

2009/07/23 14:40:30

Page 100 Page 102
Image 101
Page 100 Page 102
Contents Owner’s Record Function Setup1VMN27813 / E9PG0CD PlaybackAdditional Safety Instructions PrecautionsSymbol for Class ll Double Insulation Avoid a place with drastic temperature changes PrecautionsTo Avoid the Hazards of Electrical Shock and Fire Location and HandlingSupplied Accessories Installation LocationIR Signal Check Dew Condensation WarningCleaning the Cabinet Maintenance ServicingCleaning Discs Cleaning the Disc Lens Disc HandlingContents Contents Features Features Region Codes Unplayable DiscsColor Systems Front Panel Functional OverviewRear Panel Introduction ConnectionsUsing a Remote Control Installing the Batteries in the Remote ControlFunctional Overview Open the cover Insert batteriesSetup button Using a Remote Control cont’dThevcr / DVD Recorder Switching Disc Information/Menu Title Name Information On-Screen Display / MenuFile Name Information MP3/WMA Tag InformationOn-Screen Display / Menu cont’d Guide to ON-SCREEN Displays and MenusTitle name information File name informationMain Menu Front Panel Display Guide This is a new Power Save ECO featureDisplay Message Current status of the unitAntenna Connection Required ConnectionOverview Supplied cables used in this connection are as followsConnection Connecting to a TV Using Audio / Video Out JacksConnecting to a TV Using Component Video Out Jacks Connecting to a TV Using the S-Video Out JackSupplied cables used in this connection are as follows RF coaxial cable x RCA audio cable L/R xCopyright protection system Connecting to a TV with an Hdmi Compatible PortHdmi Video Resolution and Actual Output Signals With this setup Connecting to a Cable / Satellite BoxAfter making the connection as described above Make sure to select the appropriate input type byNo supplied cables are used in these connections Connecting to a TV without Audio / Video JacksDigital Audio Connection Multi Channel Digital Audio Setting To set up Dolby Digital, refer to pages 85, 87Setting in the Setup Menu Actual Audio Output Dolby Digital Setting DTS SettingProceed to in Manual Clock Setting on Initial SettingPress Enter to start Channel Press Enter to activate ClockAuto Channel Scan Channel SettingWhen scanning is over, press Setup to exit Press Setup to exit Channel SettingAdding/Deleting Channels Use K / L to select Manual ChannelAuto Clock Setting Setting the ClockPress Setup to exit and turn off Manual Auto Clock SettingDaylight Saving Time Setting the ClockEnter Selecting TV AudioUse K / L to select TV Audio Select, then press Enter SAP secondary audio programChoosing the Recording Format of a Brand-New DVD-RW Formatting a DiscFormatting a Disc VR mode DVD-RWReformatting a Disc Manually Use K / L to select Yes, then press EnterDisc will be protected Setting a Disc to ProtectTo cancel the disc protect Auto Finalizing Playingthe Discs in Other DVD PlayersFinalizing a Disc Playing the Discs in Other DVD PlayersUse K / L to select Finalize, then press Enter Finalizing is completedFinalizing a Disc cont’d To cancel finalizing DVD-RW onlyInformation on DVD Recording Recording ModeRestrictions on Recording VideoSetting for Auto Chapter Settings for a RecordingPress Setup to exit Make Recording CompatibleSetting Aspect Ratio for Video Mode Settings for a RecordingRecording Audio Select XP RecordingPress OPEN/CLOSE a to close the disc tray Press I/y ON/STANDBYIt may take awhile to load Disc completely Instructions continue on the nextPress REC I to start recording Basic Recording & ONE-TOUCH Timer RecordingPress Stop C to stop recording Will be displayed for 5 secondsPress B Timer RecordingUse K / L to enter the date, then Use K / L to select a recording mode Timer RecordingPress Enter when all items are entered Press Timer SET to set a timer programmingTo stop the timer recording in progress Priority of Overlapped Settings Hints for Timer RecordingConnection to an External Device Settings for AN External DeviceExternal device Supplied cables used in this connection are as followsRecording from an External Device Settings for AN External DeviceDVD/VCR Dubbing General Setting menu will appearUse K / L to select Dubbing Use K / L to select Recording, then press EnterPress Stop C to stop the recording DVD/VCR DubbingVCR to DVD DVD to VCR For DVD to VCR duplicationInformation on Playback Structure of Disc ContentsBasic Playback Refer to Using the Title/Disc Menu onDirect Playback Press Stop C once to stop playback temporarilyPress DVD Playback from the Title ListTitle, then press Enter Use K / L to select Play FromFollow steps 1 to 2 in Direct Playback on Basic PlaybackPlaying Back a DivX When selecting filePlaying Back a DivX cont’d Pause Using the Title/Disc MenuPress DVD first During playback, press Pause F Playback will be paused and sound will be mutedResume Playback Special PlaybackFast Forward / Fast Reverse Playback 40x REV 20x REVRapid Playback Special PlaybackStep by Step Playback Slow Forward / Slow Reverse PlaybackZoom Marker SettingPress DVD first During playback, press Display or Zoom Use / B to select to display the selection menuDuring recording, press Play B Chasing Playback during RecordingWhile viewing a TV broadcast via this unit, press Time Slip This unit start to record the TV broadcastSelected title playback will start Simultaneous Playback and RecordingChapter To move to for chapter, press BUsing Display Using Skip j / SkipSearch Title/Chapter SearchAudio CD SearchTime Search Random Playback Repeat Playback5Press Play B REPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE ShowProgram Playback Switching Audio Soundtrack Switching SubtitlesReducing Block Noise Switching Virtual Surround System Switching Camera AnglesSelecting the Format of Audio and Video Your setting will be activated Adjusting Black LevelUse K / L to select Black Level, then press Enter Use K / L to select OFF or ON, then press EnterGuide to a Title List Information on Disc EditingAfter the disc is fully recorded Deleting TitlesStop mode, press TOP Menu Deleting TitlesAdding Titles to a Playlist CREATING/DELETING PlaylistOriginal Use K / L to select Add To Playlist, then press EnterCREATING/DELETING Playlist Press DVD Press SetupErasing All Playlist Use K / L to select Yes, then pressPutting Names on Titles Editing DiscsTo enter a title name, follow Stop mode, press TOP MenuGuide to Edit Title Name Editing DiscsPutting Names on Titles cont’d Use Skip H / G Setting Chapter MarksPress Return Press Return again and then Return or Stop C to exitUse K / L to select Edit, then press Enter Hiding ChaptersUse Skip H or Skip G to decide the chapter to be hidden Title, then press EnterDeleting a Part of a Title VR mode DVD-RW playlistPress Return and then Return or Stop C to exit Deleting a Part of a Title cont’dUse K / L to select Delete then press Enter Use K / L/s / B to select a desired title, then press Enter Dividing a TitlePress DVD Stop mode, press TOP Menu Two titles will combine into a single title Combining TitlesYou can combine two titles into a single title Setting or Releasing the Title Protection If you select OFF at , all the chapter marks are erased Setting or Clearing All Chapter Marks at OnceUse K / L to select the desired interval, then press Enter Setup Items highlight is the default Contents List of the Default SettingsONAPR-OCT OFF List of the Default SettingsPlayback General SettingUse K / L to select a desired item, then press Enter Press Stop C if you are playing back a discParental Lock Default OFF General SettingUse the Number buttons to enter the current password Playback cont’dAudio Out Audio Language Default Original Disc Menu Language Default EnglishSubtitle Language Default OFF Angle Icon Default onScreen Saver Default 10 minutes OSD Language Default EnglishFL Dimmer Default Bright DisplayTV Aspect Default 169 Wide Progressive Default OFFVideo Selected itemDivX DivX Subtitle Default OFFDivX VOD Set the DivX subtitleHdmi Format Default RGBSet to OFF when the Hdmi sound is not output Hdmi Audio Default onRGB Range Default Normal Hdmi cont’dReset the setting to default Reset AllSelect Yes using K / L , then press Enter Information on VCR Functions Setup VCR Function OthersVCR Functions You cannot pause the one-touch timer recording One-touch Timer Recording OTRUsing REC I or Stop C VCR FunctionsOther Operations Symptom Remedy TroubleshootingTroubleshooting 102 EN Pages 23 Frequently Asked QuestionsCan I record to CD-RW/-R? Language Code Language CodeGlossary General SpecificationsRecording Input / OutputLplwhg 2QH  HDU DUUDQW\ RQ 3DUWV DQG /DERXU Limited Warranty$UELWUDWLRQ DQG Lvsxwh 5HVROXWLRQ Limited WarrantyMemo
Top Page Image Contents