Ayre Acoustics DX-7 owner manual Component Configuration

HVSync RGB Prog Rsrv C 0% 16 - 235 RGB Rsrv A

SoG YPbPr Intrlc Rsrv D 7.5% 0 - 255 YCbCr Rsrv B

RGB signals are commonly only used in the progressive mode. However, the DX-7 will also output interlaced RGB signals if so desired.

input, set the level switch to the position labeled “0 - 255”.

Component Configuration

You must first determine what input signals are supported by your display device. Please refer to the owner’s manual for your display for information.

If your display supports progressive inputs, this will provide significantly higher picture quality than an interlaced signal.

Select the desired signal by setting the toggle switch to either “Prog” or “Intrlc”.

The component outputs may also be configured for either YPbPr signals or RGB signals. If your display accepts both types of signals, the RGB configuration normally gives slightly better picture quality. Select the desired signal by setting the toggle switch to either “YPbPr” or “RGB”.

When in RGB mode, there are two common ways of sending the synchronization (”sync” or timing) signals — separate horizontal and vertical sync signals, or a composite sync signal that is included with the Green signal. The former mode is called RGB+HV and requires a five-wire connection. The latter mode is called SoG (Sync on Green) and requires a three-wire connection. Select the desired signal by setting the toggle switch to either “HVSync” or “SoG”.

10