Ayre Acoustics DX-7 owner manual Component, If in doubt about which

	this situation it is usually preferable to use an analog
	component connection rather than the DVI
	connection. This is because the digital-to-analog
	conversion in the Ayre DX-7 will perform at a
	higher level than the corresponding conversion in
	the display device.
If in doubt about which	However, a few of these CRT-based displays convert
connection to use, simply make	all incoming signals to digital for certain types of
a visual comparison to	video signal processing such as scaling. In this case,
determine which offers better	using the DVI conversion will be preferred as it
performance.	eliminates two extra conversion steps. Consult the
	owner’s manual for your display for additional
	information.
	Component
	The component interface is the highest performance
	analog interface. The component outputs can be
	configured in several ways:
	• Interlaced or progressive
	• YPbPr or RGB
	• Embedded sync or external sync (RGB only)
There are three toggle switches	When configured as progressive RGB, the sync
on the rear panel that	(timing) signals can either be added to the Green
configure the component	connection (Sync on Green, or SoG) for a total of
signal. Please refer to the	three wires, or transmitted as separate horizontal
section “Setup and	and vertical sync signals (H+V Sync) for a total of
Configuration”.	five wires.

5