Silvercrest KH 2155 manual Configuration, Setting the time, Adjust contrast

Page 11

Configuration

Setting the time

The LCD display q shows you the time of day. You set this as follows:

1.Hold down the SET button e for a little longer than 3 seconds.

2.With the or button h select "CONFIG" and confirm with the OK button l.

3.In the LCD display q appears "TIME SETUP". Confirm with the OK button l. The LCD display q now shows

"TIME" and the first number of the hour display blinks.

4.With or h place the cursor on the position, in which you want to make an entry and press the number buttons o to set the hour and minutes. The switching be- tween AM and PM you undertake with the or but- ton h. Thereby "AM" stands for "ante meridium"

(= morning, 0:00 to 12:00 o'clock) and "PM" stands for "post meridium" (= afternoon, 12:00 to 0:00 o'clock).

5.With the OK button l you save the setting. In the LCD display q appears "SUCCESS" and the previous mode is accessed again. In the event of an error the LCD display q shows "ERROR".

6.To exit this menu press repeatedly the EXIT button j until the standard display appears in the LCD display q.

Adjust contrast

You can set the display's contrast as follows:

1.Hold down the SET button e for a little longer than 3 seconds.

2.With the or button h select "CONFIG" and confirm with the OK button l.

3.With the or button h select "CONTRAST" and con- firm with the OK button l.

4.With the or h button you set the contrast (reduces the contrast, increases the contrast). Display readout:

0 = highest contrast

15 = lowest contrast

5.With the OK button l you save the desired setting. In the LCD display q appears "SUCCESS" followed by "CONTRAST".

6.To exit this menu press repeatedly the EXIT button j until the standard display appears in the LCD display q.

- 9 -

Image 11
Contents Universal Remote Control Page Index Important safety instructions Device overview First useImportant safety instructions Universal remote control KH2155$ FAV.CH button AV button Device overviewDevice buttons Inserting the batteries Unpacking the device / checking the package contentsFirst use LCD display Operating elementsChange the reception channel Set volume Volume TTX ON/OFF button Switch teletext on/offButtons ALL OFF button wButton for one/two digit programme numbers s Arrow buttons h Adjust contrast ConfigurationSetting the time Child protection on or OFF child protection off Setup System settingsBackground Illumination Child protection systemSYSTEM-SETUP overview = a = D = G = J = M = P = T Programming the remote controlProgramming by brand code search Programming by manual code input With the Exit button j you can end the Code SET modeProgramming by automatic code search Device type to the remote controlLearn function Press the Exit button j twice to exit the programming modeCode learn function Clear programmed button Programming Macros Number button Button commands = = = = = Execute a MacroPress the Macro button 2@ Favourites channel Tips Back to volume control Volume controlFurther volume control functions except PC Vol +/-, Mute switchingEntry press the button s Additional functionsAll OFF Automatic station redirecting Alternative button allocation in teletext modeButton Normal function Function in TTX mode Button Normal function Function in PIP mode Faults / RemediesAlternative button allocation in PIP mode Disposal Importer Technical dataImportant Warranty Notices CE- ConformityPage Mail support.ie@kompernass.com WarrantyDescription of fault