Silvercrest Comprehensive Guide to Programming Your Remote for TV Control

Page 15

Repeat these operational steps for all devices that you would like to control with the remote control.

Programming by manual code input

In this mode the remote control can be programmed by direct input of a code number. Please extract the necessary code number from the accompanying code list. In the event that the new code is invalid the last valid programmed code will be restored.

1.Hold down the SET button e for a little longer than 3 seconds.

2.In the LCD display q appears "CODE SETUP". Press the OK button l. "BRAND SRCH" now appears in the LCD display q. Press the or button h until "CODE SET" is shown in the LCD display q. Then press the OK button l.

3.In the LCD display q appears the last programmed device and the code used.

4.Press the desired device button r (i.e. VCR). The target device now blinks and waits for your confirmation.

5.With the OK button l confirm the selected device. Now the first digit of the code blinks and waits for your code input.

6.Enter the 3 digit device code with the number buttons and confirm the entry with the OK button l.

7.If the entered code is valid for the selected device type then the code will be saved. In the LCD display q appears "SUCCESS" and then again "CODE SET". In the event of failure the LCD display q shows "NOT FOUND" and waits for a new code input. Then you repeat step 6.

8.For many combi-devices you must enter 2 codes from the accompanying list, i.e. one for the TV section and one for the DVD section. If the code of a combi-device (i.e. TV-DVD) is shown in the list as "XXX XXX" then apply the first 3 numbers for the device named first in the device denomination (=TV), and the last 3 numbers for the device named second (=DVD).

9.With the EXIT button j you can end the CODE SET mode.

- 13 -

Image 15
Contents Universal Remote Control Page Index Important safety instructions Device overview First useImportant safety instructions Universal remote control KH2155Device overview Device buttons$ FAV.CH button AV button Unpacking the device / checking the package contents First useInserting the batteries LCD display Operating elementsChange the reception channel Set volume Volume TTX ON/OFF button Switch teletext on/offButtons ALL OFF button wButton for one/two digit programme numbers s Arrow buttons h Configuration Setting the timeAdjust contrast Child protection on or OFF child protection off Setup System settingsBackground Illumination Child protection systemSYSTEM-SETUP overview Programming the remote control Programming by brand code search= a = D = G = J = M = P = T Programming by manual code input With the Exit button j you can end the Code SET modeProgramming by automatic code search Device type to the remote controlLearn function Press the Exit button j twice to exit the programming modeCode learn function Clear programmed button Programming Macros Button commands = = = = = Execute a Macro Press the Macro button 2@Number button Favourites channel Tips Back to volume control Volume controlFurther volume control functions except PC Vol +/-, Mute switchingAdditional functions All OFFEntry press the button s Alternative button allocation in teletext mode Button Normal function Function in TTX modeAutomatic station redirecting Faults / Remedies Alternative button allocation in PIP modeButton Normal function Function in PIP mode Disposal Importer Technical dataImportant Warranty Notices CE- ConformityPage Mail support.ie@kompernass.com WarrantyDescription of fault