8.If the device does not react again carry on switching every 1.5 seconds with the button h to the previous code until the device reacts.
9.Then press the OK button l to save the code. The LCD display q shows "SUCCESS" and then returns again to the "AUTO SEARCH" mode.
10.Press the EXIT button j twice to exit the programming mode.
11.Check to see if the majority of your device's functions can be controlled with the remote control. In the event that a few functions are not working you can start the automatic code search again beginning with step 1.
Tips:
If the PAUSE ;button d is pressed during the automatic code search the code search stops. Pressing on the PAUSE ; button d again allows the device to take up the search once more.
1.During an active code search all buttons except OK l, PAUSE ; d, , h and EXIT j will be ignored.
2.If the EXIT button j is pressed during the code search the search will stop and the "AUTO SRCH" status is again accessed without the code being saved.
3.Should the correct code be found, however the device's original remote control did not have a POWER button then it is possible that the device cannot be switched on or off remotely. Then try the buttons4 h, CH + y or MUTE 2#.
4.If the automatic search has reached the end of the code list it stops there. Then press the EXIT button j to return to the "AUTO SRCH" mode and start again with step 4.
5.If you want to programme an AUX device by automatic code search the device type must first be defined by direct code input. After which you carry out the auto- matic code search from step 5.
Learn function
The Universal remote control (URC) can learn and save button signals of an original remote control. If the URC does not work after applying the programming methods already described or cannot carry out all commands please attempt to teach the URC with the help of the original remote control.
•Use new batteries for the URC and the original remote control.
•Maintain a distance of at least one metre from other light sources. The light sources could disrupt the infrared trans- mission.
•Place the URC and the original remote control at a distance of 25 to 55 mm from each other on an even surface so that the Infrared diodes 2^ are facing each other.
- 15 -