Silvercrest KH 2155 manual First use, Unpacking the device / checking the package contents

Page 6

First use

Unpacking the device / checking the package contents

Attention!

Keep the plastic packaging well away from small children.

There is a risk of suffocation.

•Unpack the device and accessories.

•Check the package contents,

-Universal remote control,

-Operating instructions,

-Manufacturer list with device code list

•Remove the protective foil from the LCD display q.

Note: Transport damage

If you notice any transport damage contact the manufacturer or the manufacturer's Service-Hotline (see warranty card).

Inserting the batteries

Attention!

The Universal remote control must only be operated with 1.5 Volt batteries (Type AAA, LR03).

Carry out the battery change as quickly as possible. Preset settings will remain saved for approx. 1 minute. If new batteries have not been installed within this time all of the settings will have to be carried out again. The time of day will, however, in any case be deleted.

1.Open battery compartment cover 2& in the direction of the arrows.

2.Insert the batteries as shown in the diagram and close

the battery compartment.

The LCD display q is activated as long as batteries are installed. The following diagram shows the LCD display q after the batteries have been installed or changed.

- 4 -

Image 6

Contents Universal Remote Control Page Important safety instructions Device overview First use IndexUniversal remote control KH2155 Important safety instructionsDevice overview Device buttons$ FAV.CH button AV button Unpacking the device / checking the package contents First useInserting the batteries Operating elements LCD displayALL OFF button w Set volume Volume TTX ON/OFF button Switch teletext on/offButtons Change the reception channelButton for one/two digit programme numbers s Arrow buttons h Configuration Setting the timeAdjust contrast Child protection system Setup System settingsBackground Illumination Child protection on or OFF child protection offSYSTEM-SETUP overview Programming the remote control Programming by brand code search= a = D = G = J = M = P = T With the Exit button j you can end the Code SET mode Programming by manual code inputDevice type to the remote control Programming by automatic code searchPress the Exit button j twice to exit the programming mode Learn functionCode learn function Clear programmed button Programming Macros Button commands = = = = = Execute a Macro Press the Macro button 2@Number button Favourites channel Tips Vol +/-, Mute switching Volume controlFurther volume control functions except PC Back to volume controlAdditional functions All OFFEntry press the button s Alternative button allocation in teletext mode Button Normal function Function in TTX modeAutomatic station redirecting Faults / Remedies Alternative button allocation in PIP modeButton Normal function Function in PIP mode Disposal CE- Conformity Technical dataImportant Warranty Notices ImporterPage Warranty Mail support.ie@kompernass.comDescription of fault