Silvercrest KH 2155 manual Faults / Remedies, Alternative button allocation in PIP mode

Page 27

Alternative button allocation in PIP mode

Note:

The PIP function (picture in picture) is only available in the TV mode. Your TV device must support this function.

You switch the PIP function on and/or off with the PIP button. If the remote control is in the PIP mode the following buttons serve as controllers for the PIP functions:

Button	Normal function	Function in PIP mode
	move up in the	PIP +
	menu
	move down in the	PIP —
	menu
	switch to AV	PIP source

	move left in the	PIP size
	menu

	move right in the	PIP position
	menu

Faults / Remedies

Your device does not react to the remote control.

>> Check the batteries. They must have enough voltage and be properly installed.

>> Firstly have you pressed the correct device button r for the desired target device?

>> Check to see that the correct code is programmed in for the target device (see section "Programming the remote control").

The remote control is transmitting the commands in- correctly.

>> Press the corresponding device button to set the remote control to the correct mode.

>> The batteries must have enough voltage and be properly installed.

>> It is possible that you are using the wrong code. Start the brand code search, the automatic code search or the direct code input (manual).

- 25 -

Image 27

Contents Universal Remote Control Page Index Important safety instructions Device overview First useImportant safety instructions Universal remote control KH2155Device overview Device buttons$ FAV.CH button AV button Unpacking the device / checking the package contents First useInserting the batteries LCD display Operating elementsChange the reception channel Set volume Volume TTX ON/OFF button Switch teletext on/offButtons ALL OFF button wButton for one/two digit programme numbers s Arrow buttons h Configuration Setting the timeAdjust contrast Child protection on or OFF child protection off Setup System settingsBackground Illumination Child protection systemSYSTEM-SETUP overview Programming the remote control Programming by brand code search= a = D = G = J = M = P = T Programming by manual code input With the Exit button j you can end the Code SET modeProgramming by automatic code search Device type to the remote controlLearn function Press the Exit button j twice to exit the programming modeCode learn function Clear programmed button Programming Macros Button commands = = = = = Execute a Macro Press the Macro button 2@Number button Favourites channel Tips Back to volume control Volume controlFurther volume control functions except PC Vol +/-, Mute switchingAdditional functions All OFFEntry press the button s Alternative button allocation in teletext mode Button Normal function Function in TTX modeAutomatic station redirecting Faults / Remedies Alternative button allocation in PIP modeButton Normal function Function in PIP mode Disposal Importer Technical dataImportant Warranty Notices CE- ConformityPage Mail support.ie@kompernass.com WarrantyDescription of fault