6.SCHEDULE RECORD
SCHEDULE SETUP
0 3 6 9 12 15 18 21 24
[RIGHT,LEFT] TO MOVE [MENU TO EXIT] [UP,DOWN] TO SELECT
Press ▲ or ▼ key on "SCHEDULE RECORD" & ◄ or ► to enter:
Use the ◄ or ► button to select items. Press the ▲ or ▼ button to confirm the selection.
Press MENU to go back to SETUP MENU.
There are 24 circles in the schedule table, which represent 24 hours. Every circle has 3 options to select:
O : represents "fully record"
X : represents "no record"
A : represents "alarm record"
Use the ◄ or ►button to select hours.
Press ▲ or ▼ button to select the O / X / A (Fully / No / Alarm Record).
QUICK KEY:
Play
Key to switch between O / X / A (Fully / No / Alarm Record) in all hours.
7.EVENT LIST
EVENT LIST
HDD1: MASTER
START TIME: 2005/MAY/16 12:07:00 END TIME: 2005/MAY/16 12:07:30
>01 RECORD 2005/MAY/16 12:07:00 02 MOT CH1 2005/MAY/16 12:06:00 03 MOT CH2 2005/MAY/16 12:05:00 04 POWER 2005/MAY/16 12:04:00 05 ALM CH1 2005/MAY/16 12:03:00 06 ALM CH2 2005/MAY/16 12:02:00 07 ALM CH3 2005/MAY/16 12:01:00
Press ▲ or ▼ key on "EVENT LIST" & ◄ or ► to enter:
Use the ◄ or ► button to select items. Press the ▲ or ▼ button to confirm the selection.
Press MENU back to SETUP MENU.
Use "▲ or ▼" key to select event which needs to be played，location of " > " symbol will move up and down for indicating current event which been selected.
Press "◄ or ►" key to select events storage from master hard drive or slave hard drive. When once selection has been made and than press ►PLAY key to start playback. There are totally 4 different type's event will be recorded:
1.RECORD：Event starts recording by press "REC" key.
2.POWER：When power off or loss, system would add this issue, and "POWER
ERROR DETECTED" would show on screen while boot.
3.ALM CH1：When external alarm was triggered, event up with alarm number.
4.MOT CH1：When motion detection was triggered, event up with alarm number.
12