Sampo DR-S0426 manual Copyright

Page 2

INSTRUCTION MANUAL

To obtain the best performance and ensure device function correctly, please read this instruction manual carefully and completely.

FCC Compliance

USER-INSTALLER CAUTION: YOUR AUTHORITY TO OPERATE THIS FCC VERIFIED EQUIPMENT COULD BE VOIDED IF YOU MAKE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE TO PART 15 OF THE FCC RULES.

NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS A DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE WHEN THE EQUIPMENT IS OPERATED IN A COMMERCIAL ENVIRONMENT. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS.

OPERATION OF THIS EQUIPMENT IN A RESIDENTIAL AREA IS LIKELY TO CAUSE HARMFUL INTERFERENCE IN WHICH CASE THE USER WILL BE REQUIRED TO CORRECT THE INTERFERENCE AT HIS OWN EXPENSE.

THIS CLASS A DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE-CAUSING EQUIPMENT REGULATIONS.

WARNINGS, CAUTIONS & COPYRIGHT

WARINGS

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MISTURE.

DO NOT INSERT ANY METALLIC OBJECT THROUGH VENTILATION GRILLS.

CAUTION

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

Explanation of Graphical Symbols

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of insinuated "dangerous voltage" within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral rhombus is intended to alert the user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the product.

USERS OF THE SYSTEM ARE RESPONSIBLE FOR CHECKING AND COMPLYING WITH ALL FEDERAL, STATE, AND LOCAL LAWS AND STATUTES COIPCERNING THE MONITORING AND RECORDING OF VIDEO AND AUDIO SIGNALS. ULTRAK SHALL NOT BE HELD RESPONSIBLE FOR THE USE OF THIS SYSTEM IN VIOLATION OF CURRENT LAWS AND STATUTES.

COPYRIGHT

THE TRADEMARKS MENTIONED IN THE MANUAL ARE LEGALLY REGISTERED TO THEIR RESPECTIVE COMPANIES.

ii

Image 2
Contents DR-S0426 / DRE-S0426P Copyright Table of Contents Setup Menu List Chapter Introduction Buttons Function List ChapterFront Panel Layout Overview Part LabelPlay Menu 23 HDD/CDRWEthernet VGA Setup DIPPower / Power SW LEDChapter Setup Procedures Menu Setup Protect ON/OFF System SetupTime Display Mode Change PasswordCamera Select CAM1/CAM2/CAM3/CAM4 Camera SetupMotion Area Setup Camera Record ON/OFFAlarm Record FPS Record SetupRecord Mode MUX/QUAD Alarm Record Dwell 1~30SECMotion Alarm ON/OFF Alarm SetupVideo Loss Alarm ON/OFF External Alarm ON/OFFPlay Schedule RecordQuick KEY Event ListPassword Correct Overwrite Mode YES YES/NOPassword Input HDD ManagementSlave HDD Capacity Password Incorrect Change PasswordHard Disk Formatted Slave HDD Left RatioCamera Setup ON/OFF Load DefaultSystem Setup ON/OFF Record Setup ON/OFFRecording Chapter Operation ProceduresGetting Started with your machine PlaybackTime Search Hard Drive MasterHard Drive Slave Several ways to perform playbackStart TIME:2005/MAY/05 END TIME:2005/MAY/05 Hard disk VCR BackupAlarm control VCRCOM External alarm connectorGND DIP1 DIP2 DIP3 DIP4 VGA OutputRS-485 control protocol Jpeg Chapter SpecificationsNtsc PAL Chapter Recording Time Length Chapter Hard Drive Installation Procedures Page A11633RM4F17