Connecting
Back panel US version
1 | 2 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
3
-
+
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
14 |
| 15 |
|
| 16 | 17 | 18 |
1IR OUT 1, 2 Infrared flasher connectors
Allow the control via the handset of auxiliary devices that accept infrared signals.
2MAIN RX TX CONNECT LED indicators
Indicate signals being transmitted between units in a CONNECT system.
3ACC KNEKT connector
For installing unit in a KNEKT system.
4ROOM 1 - 4, MAIN IN CONNECT connectors
For linking units in a CONNECT system (see CONNECT chapter).
5ROOM RX TX CONNECT LED indicators
Indicate signals being transmitted between units in a CONNECT system.
6GND, AM
AM aerial connectors.
7FM Aerial
FM aerial connector.
8MONITOR OUT
For connection to a TV that accepts an
9S VIDEO IN
For connection from a VCR with an
10VCR input and output connectors
12
115
13
11TV input and output connectors
12Voltage selector
13MAINS INPUT
14Speaker output connectors
Amplified output for direct connection to speakers.
15PRE OUT Line output connectors
Connections for power amplifier, and subwoofer output.
16TAPE OUT, TAPE IN
For connection to a tape recorder.
17AUX IN
Input from an auxiliary source.
18DIGITAL OUT
For connection to a device with digital input capabilities.
The Classik Movie System should be powered down then disconnected from the mains supply before connecting or disconnecting any of the plugs on the back panel. If this is not done you may generate surges which could damage the Classik Movie System or other components in your AV system.
6