Linn Linn Classic Movie System manual Signal mute level, To adjust the signal mute level

Page 38

Tuner

Signal mute level

To adjust the signal mute level:

 

using the handset -

 

● After pressing SIGNAL, to increase or decrease the signal mute level, repeatedly

 

press or hold / .

 

Two minutes after the signal mute level has been adjusted, the display reverts to its

 

previous display.

 

SIGNAL

 

NOTE:

 

Signal mute level is factory-set at 15.

The mute level function allows you to mute the output from the tuner if the strength of a signal is below a set level.

EXAMPLE:

If you set the mute level at 25, then the tuner will mute any received frequency that is below 25.

To display the mute level and signal strength:

using the handset -

●Press SIGNAL.

MUTE LEVEL and its value appear on the front panel display, followed by the mute level display bar.

The current signal strength appears on the far right of the display. Signal strength ranges from 0 (no signal) to 50 (strongest signal). The figure may fluctuate, reflecting the varying strength of the signal being received.

32

Page 37 Page 39
Image 38
Page 37 Page 39
Contents
Page Page Important Safety Information Mains PlugsMains plug replacement This Appliance Must be EarthedFCC notice Date of issue Test typeCE Declaration of Conformity Copyright and Acknowledgements Contents Tuner Connect FeatureGuarantee and Service Technical Specification PreamplifierDiscs CleaningIntroduction Important Note Disc formatsVoltage selection ConnectingUnpacking PositioningTV Scart GND, AMVideo Mains InputBack panel US version VCR input and output connectorsTV input and output connectors Voltage selector Connecting to a TV European version Connecting the Classik Movie SystemConnecting the aerials Connecting to a mains supplyConnecting to a VCR US version Connecting to a TV US versionConnecting to a VCR European version Connecting to an external power amplifier Connecting to speakersConnecting to an analogue tape recorder Connecting to an auxiliary sourceDisc drawer Front panel display Front Panel and HandsetFront panel Handset modes Volume / volume + Adjust the volume levelHandset Setup Menus About the setup menusTV Type Exiting from the setup menusTV Display Captions Picture ModeAngle Mark Screen SaverCentre FrontSmall RearTest Tone Dynamic Audio OUTDual Mono PRO LogicAudio PasswordDefaults SubtitleFront panel display Playing DiscsFirst of all DVDs Basic operationTo play a disc CDsTo stop playback and remove a disc Locating titles/chapters/tracks on a discTo pause a disc Direct title selectionNext and previous chapter/track selection Using the front panelTo play a particular track Using the handset Direct chapter selectionFast scan forwards and backwards Locating a particular point on a discFast search forwards and backwards Fast SearchSlow search forwards and backwards Slow scan forwards and backwardsDirect time selection To repeat an entire disc or DVD title Using the handsetTo repeat a specific chapter/track Using the handset Repeat discIntro program Repeat sectionShuffle program Include programExclude program Using DVD menusTo clear a stored program or cancel exclude program mode Title/DVD menuAngle selection Further playback options for DVDsLanguage selection Zoom and panTo toggle between Midnight Movie mode on or off Midnight Movie modeAudio mode Speakers used Surround sound audio modesAM and FM band selection Tuning functionsTuner Frequency selectionUsing the front panel or handset Signal searchingSignal scanning To search for signals Using the handsetSignal mute level To adjust the signal mute levelAutomatic preset storage Preset functionsPreset storage To store a frequency as a preset Using the handsetAudio modes Preset selectionPreset deletion Preamplifier Volume and mutingVolume adjustment Mute and unmuteFader balance Subwoofer trim adjustmentBalance adjustment Master balance Bass and treble adjustmentBass adjustment To exit treble adjustment Treble adjustmentTo adjust the level of treble Record lock Record FunctionMaking a recording Listen and record sourcesAbout Connect Connect FeatureSetting up a Connect system Switching between Main Mode and Local Mode Party ModeMain Mode and Local Mode Controlling the driver unit from a receiver unitParty Poop Restrictions to Party ModeVolume control in Party Mode Programming the handset To enter TV modeTV Control Controlling the TVLanguage Codes Language CodeUser Options Changing the user options’ settingsTo change the user options’ settings Using the front panel Table of user options USA Guarantee and ServiceTechnical support and information Video Technical SpecificationGeneral Tuner Multi Room Page Page Pack