S P E C I A L F E AT U R E S
Setting Up Your Remote Control to Operate Your Cable Box
1
Turn off your cable box.
2
Press the MODE button and make sure that the Cable LED is illuminated.
▼ | The remote control has four |
“modes”: “TV,” “VCR,” “CABLE” and “DVD.”
Press the “MODE” button to switch the remote control to the “Cable” mode.
3
On your Samsung remote control, press SET.
4
Enter 3 digits of the cable box code listed below for your brand of cable box.
5
Press Power. Your cable box should turn on. If your cable box turns on, your remote control is now “set up” correctly.
6
Once your remote control is set up, press the MODE button any time you want to use the remote to operate your cable box.
▼ | Make sure you enter 3 digits of |
the code, even if the first digit is a “0.” (If more than one code listed, try the first one.)
▼ | If your cable box does not turn |
on, repeat steps 2, 3, and 4, but try one of the other codes listed for your particular brand of cable box. (If no other codes are listed, try each cable box code, 000 through 077.)
▼ | When your remote control is |
in the “CABLE” mode, the volume buttons still control your TV’s vol- ume. Also, the VCR control buttons (PLAY, PAUSE, etc.) will still operate your VCR.
4.16 CHAPTER FOUR: SPECIAL FEATURES