Samsung ST-54T6, ST-62T6 manual Adjust Red Convergence, Adjust Blue Convergence

O P E R AT I O N

Adjust Red Convergence

4

While “Red” is highlighted (letters are blue color), press the VOL+ button:

A crosshair pattern will appear on the screen. If either a vertical or a horizontal red line is visible, then the convergence needs alignment.

5

If a horizontal red line is

visible, use CH▲ and CH▼ buttons to move the line so that it is super- imposed on the horizontal center- line (i.e., make a single horizontal line that is as white as possible.)

Please, use remote control

R

Up/Down

± L/R

Menu

Please, use remote control

R

Up/Down

± L/R

Menu

6

If a vertical red line is visible, use the VOL + and VOL - buttons to move the line so that it is superim- posed on vertical-center line (i.e., make a single vertical line that is as white as possible.)

7

At this point, the Red convergence is correctly adjusted. Press MENU, then press the CH▼ button once to highlight the word “Blue.”

Please, use remote control

R

Up/Down

± L/R

Menu

SET UP

Manual convergence

Red

Blue

Move ± Ent. Menu

Adjust Blue Convergence

8

While the word “Blue” is highlight- ed, press the VOL+ button to adjust the blue convergence. When the crosshair pattern appears, use CH▲ and CH▼ and VOL + - to converge the blue line (same procedure as in steps 1~7, above).

Please, use remote control

B

Up/Down

± L/R

Menu

9

After the blue convergence is

correctly adjusted, press MENU four times to exit all the menus.

3.2 CHAPTER THREE: OPERATION