Samsung ST-54T6, ST-62T6 manual Viewing a VCR or Camcorder Tape, Video1 Video2 Video3

Page 34

O P E R AT I O N

Viewing a VCR or Camcorder Tape

You must select the appropriate mode in order to view the VCR or Camcorder signal on the TV.

1

Make sure that the remote control is controlling the TV set. (Press the MODE button and make sure that the “TV” LED is illuminated.)

2

Press TV/VIDEO on the remote control, and the following on- screen menu will appear:

TV/Video Menu

ANT/CATV

Video1

Video2

Video3

S-Video1

S-Video2

DVD

3

Use the CH▲ or CH▼ button to highlight a particular signal source, and then press VOL+ to activate it.

Press TV/VIDEO to exit.

ANT 4

ANT/CATV
Video 1		Connected
Video 2		Connected
Video 3		Connected
S-Video 1		Not connected
S-Video 2		Not connected
DVD		Not connected
Move	± Ent. TV/Video Exit

When you press the TV/Video button, the on-screen display identifies all the active video sources (and their corresponding input jacks):

Select	Video jack	Audio jack
Video 1	Video 1 (rear panel)	Audio 1 "L+R"
Video 2	Video 2 (rear panel)	Audio 2 "L+R"
Video 3	Video 3 (front panel)	Audio 3 "L+R"
S-Video 1	S-Video 1(rear panel)	Audio 2 "L+R"
S-Video 2	S-Video 2 (front panel)	Audio 3 "L+R"
DVD	DVD-rear	DVD Audio "L+R"

3.14 CHAPTER THREE: TV OPERATION

Image 34

Contents Owner’s Instructions Risk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding Your New TV InstallationOperation Special Features TroubleshootingList of Features Chapter OneFamiliarizing Yourself with The TV ´ Video in jack Front Panel JacksAudio in jacks Super Video Input jackSuper Video Input Rear Panel JacksAudio Inputs Number buttons Remote ControlPIP +100Remote Control ¸ VCR controls PIP ControlsConnecting VHF and UHF Antennas Antennas with 300-ohm Flat Twin LeadsSeparate VHF and UHF Antennas Connecting Cable TVAntennas with 75-ohm Round Leads Cable without a Cable BoxConnecting to a Cable Box that Descrambles Some Channels Connecting to a Cable Box that Descrambles All ChannelsConnect this cable to a two-way splitter Connecting a VCR Connecting an S-VHS VCR Antenna or cable to your VCR and your TVConnecting a Second VCR to Record from the TV Connecting a Camcorder Installing Batteries in the Remote Control Turning the TV On and Off Adjusting Basic ConvergencePress Power Press VOL +Adjust Blue Convergence Adjust Red ConvergenceIf a horizontal red line is Viewing the Menus Viewing the Menus and On-Screen DisplaysViewing the Display Selecting a Menu Language Press Menu to display the menuSelecting the Video Signal-source Memorizing the ChannelsPress VOL + again Press MENU, then press CH twice to highlight SET UPStoring Channels in Memory Automatic Method TV will beginChanging Channels Using the Channel ButtonsDirectly Accessing Channels Adding and Erasing Channels Manual MethodPress the CH or CH button to select the correct minutes Setting the ClockPress Menu three times to exit Using Mute Adjusting the VolumePress VOL + or VOL to increase or decrease the volume Customizing the Picture Video icon will be highlighted starts blink- ingUsing Automatic Picture Settings Alternate methodCustomizing the Sound Using Automatic Sound Settings Press TV/VIDEO to exit Viewing a VCR or Camcorder TapeVideo1 Video2 Video3 Select Video jack Audio jackSetting Up Your Remote Control to Operate Your VCR Customizing Your Remote ControlTurn off your VCR DVD Codes Setting Up Your Remote Control to Operate Your Cable BoxVCR Codes Turn off your cable boxCable Box Codes NSCPress CH to select On time Setting the On/Off TimerPress CH twice to highlight Time Press VOL + Press CH or CH to select the appropriate minutesSetting the Sleep Timer Press VOL+ Viewing Closed CaptionsPress VOL+ to open the Caption menu Fine Tuning Channels Select the appropriate channel Press MenuLNA Low Noise Amplifier Press CH twice to highlight LNAChoosing a Multi-Channel Sound MTS Soundtrack Special Audio Options MTS and HeadphonesPress CH to highlight MTS Setting up Wireless Headphones with Picture-in-Picture Using Wireless HeadphonesTurn the transmitter and Wireless Headphones on Press VOL + to select the PIP menu Viewing Picture-in-PictureActivating Picture-in-Picture Press VOL + to select PIP OnSelecting a Signal Source External A/V for PIP Selecting a Signal Source Antenna or Cable for PIPSwapping the Contents of the PIP image and Main image Freezing the PIP Image Changing the PIP ChannelChanging the Location Rotating the PIP Window Changing the Size of the PIP WindowUsing the V-Chip Setting Up Your Personal ID Number PINHow to Set up Restrictions Using the TV guidelines How to Enable/Disable the V-ChipPress CH six times to highlight the V-chip menu Press VOL+ Parental guidance TV-Y Young children TV-Y7 Children 7 and overGeneral audience TV-14SET UP Mpaa Rating Identifying Problems Chapter FiveUsing Your TV in Another Country Cleaning and Maintaining Your TVSpecifications