Menu Operation
1. DiSEqC Mode 
Supports DiSEqC 1.0 and 1.2.
1.1 DiSEqC 1.0
=2, 4, or 8 port can be selected for DiSEqC switch box. You can select and
use the appropriate port for your DiSEqC switch box.
=Use the 
buttons to select 2SW,
4SW, or 8SW in the Installation DISEqC Mode. And then press the 
button.
=Connect the satellite LNB line to the appropriate port. To use the port, press the
buttons to set the satellite you want.
Any unused port must be set OFF.
=Press the
button or 
button to save the set data.
1.2 DiSEqC 1.2
You can use the DiSEqC 1.2 motorized system, if it exists.
Setting
=Use the 
buttons to select the
Motor from the Installation DiSEqC Mode. And then press the 
button.
=You can set the Position within the numbers 0 ~ 59 (60). Select the number you want.
=Select the name of Satellite.
=Select the number of TP which has a good signal from the TP List.
=Use the FINE DRIVE, INSTALLER to run the MOTOR. And then move the antenna to the appropriate satellite.
=Press the 
button in the Save position to save the set data.
Searching
=Use the 
buttons to search for the Position and find the name of satellite you want.
= Press the | button in the Go to Position to move to the set position. |
=Select the channel you want to watch after changing the satellite from the Channel List. Then, the antenna automatically moves to the set position.
20