Universal Remote Control RF10 manual MacroPower Setup

19	MacroPower™ Setup				20
MacroPowerTM Setup					MacroPowerSetupTM
	button. In addition to the Power ON or OFF buttons, any of
	MacroPower™ is a unique feature that enables you to turn
	all of your Components ON or OFF, at the same time, simply
	with the press of one button. We call that a “Macro”.
	What would normally take multiple remotes and button
	pushes, the RF10 can accomplish with the press of one
	the Component buttons can be set to be Macro buttons as
	well. Feel the power!
	To setup a Power ON macro button that will turn ON several
	components at the same time (for example, TV, VCR and
	CABLE), follow these easy steps:
	STEP 1:	STEP 2:	STEP 3:	PROGRAMMING A
	Press and hold both the ON	Press the first COMPONENT	Once you have entered all the	“PRESS & HOLD” MACRO:
			desired Power On commands,	Another option for macro buttons
	button and the MUTE buttons at	button you want to turn on
			press the CHANNEL ( ) UP	is to only send the macro
	the same time for approximately	(in this example, TV) and then
			button to save your MacroPower
				commands if the button is
	3 seconds, until the word	confirm the command by	commands. The RF10 will
	“MACRO” is displayed on the	pressing the ON button. Repeat	respond by flashing “SAVED”	pressed and held. This is setup
	LCD screen. This signals that	this step for all the other	twice, then automatically return	by entering a delay as the first
			to normal operating mode.	step of the macro. The amount of
	you are now in MACRO Setup	components in the order you
				delay determines how long the
	mode.	want them to turn on (in this	SETTING UP A POWER OFF OR
				user must press the button
		example, VCR followed by
			A COMPONENT BUTTON AS
				before the macro is sent. The
SETUPADVANCED		CABLE). The LCD screen			ADVANCEDSETUP
			MACRO:
				advantage of this option is that a
		changes to the MACRO step
			If you want to program macro
				normal press of the COMPONENT
		display for each command.
			commands for the OFF or one of
				button will simply switch
			the 8 component buttons, in
				Components without sending the
			STEP 1, simply press the button
				macro command.
			you want to be a macro instead
			of the ON button. For example,
			you can setup an AUDIO button
	IMPORTANT:You now have 30 seconds
			to be a macro by pressing AUD
	to perform the next step while you are
			(Audio) and MUTE for 3 seconds.
	in MACRO mode. If you don’t press a
	button within 30 seconds, MACRO will		Once the screen displays
		(NOTE: Whenever a button is pressed, another
	disappear from the screen, signaling
		Macro step is counted and displayed on the	“MACRO”, press the button with
	that you have exited MACRO Setup
		screen.)
	mode and you will need to start over.		the command you want. Then
		NOTE: Don’t worry about the number of steps.
			complete and save the Macro
		Each macro button can store up to 50 steps, so
			by following STEP 3 as outlined
		you are not likely to run out of steps!
		You can also program delays in between com-	above.
		mands by pressing the (II) PAUSE button. Each
		press adds half a second to the delay.