15
Learning Method
Transmitting (Busy Signal) Icon
When a command is being transmitted, an icon will appear in the far right side of the LCD screen. This indicates that a signal is being sent.This is particularly useful when setting up Macros, since it flashes with every step of a sequence of commands.
16
Transmitting (Busy Signal) Icon
STEP 5:
Once you have completed teaching all the button commands to the RF10, save your work and return to normal operation by pressing both the COMPONENT button you pressed in STEP 2 and the ENT (Enter) button at the same time. The remote will respond by flashing SAVED on the display twice, then return to normal operating mode.
NOTE: Test all your new commands. If any of them don’t work, try the Learning Method again, following these suggestions:
•Try tapping the button on your old remote instead of pressing and holding it during the learning process.
Some additional Information regarding the Learning Process:
•Learned functions override any existing
•All buttons can be learned except for the PAGE, MAIN and LIGHT buttons.
•Learned functions are automatically erased when a new function is learned on the same button.
CHILD LOCK FEATURE
This
To Activate:
Press the +10 and ENT (Enter) buttons simultaneously for
3 seconds. The LCD will blink “LOCK” three times and then display “LOCK”.
To Return to Normal Operation:
Press the +10 and ENT (Enter) buttons simultaneously again for 3 seconds. The LCD will display the last use mode.
BASIC SETUP
•Move to another room. Plasma TVs, sunlight, halogen or quartz lighting can interfere with the learning process.
•Even though the old remote seems to be working fine, put in fresh alkaline batteries.
•Gradually vary the distance between the remote controls. Try 1”, 2” and so on, up to 4 feet.
•Learned functions are retained even after a different Setup Code Number is programmed into the remote.
•To return to an original
a learned function must be erased.