Basic Setup Overview | Universal Remote Control RF10 manual

Pre-Programmed Code Method

Basic Setup - Overview

There are three ways to program the RF10:

>The Pre-Programmed Code Method

>The Pre-Programmed Auto-Search Method

>The Learning Method

The Pre-Programmed Code Method allows you to setup all the buttons at once, so it’s the fastest and easiest of the three methods. The Auto-Search Method scans through all the codes in the RF10, one at a time. The Learning Method allows you to transfer functions from other remotes (old or new), one button at a time.

Pre-Programmed Code Method

BASIC SETUP

STEP 1:

The pre-programmed 3-digit codes are found in the back of

this Manual on page 38. The

codes are listed by Component category (i.e., TV, VCR, DVD, etc.), then by brand name. For instance, if you want to locate a code for a Sony TV, first locate the TV category, and then look for the Sony brand.

Once you have located the

3-digit code (or in some cases, several code numbers) for the Component that you want to operate with your RF10, write them ALL down on a piece of note paper. It’s important that you write down all the codes because only one code is going to work for you.

STEP 2:

Now, turn on the Component you want to program… let’s say your TV to start. Look up your TV’s manufacturer setup code from your reference list.

STEP 3:

Press and hold the COMPONENT button (in this case TV) and SELECT button at the same time for approximately 3 seconds. The LCD screen will display “SET” signaling that you are now in Setup mode and ready to program your TV.

IMPORTANT:You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SET will disappear from the screen, signaling that you have exited setup mode and you will need to start over.

COMPONENT

BUTTON

SELECT

BUTTON

BASIC SETUP