Advanced Setup

Recalling Pre-Programmed Setup Code Numbers

Recalling Pre-Programmed

Setup Code Numbers

In case you didn’t write down the Pre-Programmed Code Numbers that you used to setup your RF10, you can easily recall them using this simple process:

STEP 1:

Press and hold both the COMPONENT you want to iden- tify and the SEL (Select) buttons at the same time for approximately 3 seconds, until the word “SET” is displayed on the LCD screen. This signals that you are now in setup mode.

IMPORTANT:You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over.

STEP 2:

Press the INFO button. The name of the selected component will blink twice on the LCD screen, followed by the 3-digit code. Write down the code numbers as they appear for future reference. Pages 37 of this manual provides a convenient space for you to record your code numbers.

The RF10 will then automatically return to normal operating mode.

ADVANCED SETUP