Toshiba 51H94 Setting up your TV, Selecting the menu language Configuring the antenna input

6 Setting up your TV

For menu navigation instructions, see Chapter 4.

Selecting the menu language

Configuring the antenna input

sources

You can choose from three different languages (English, French

and Spanish) for the on-screen display of adjustment menus and

To configure the ANT 1 and ANT 2 input sources:

messages. (The TV Guide On Screen menus are in English,

regardless of the language selected in this menu.)

1. Press MENU and open the SETUP menu.

To select the menu language:

2. Highlight INSTALLATION and press ENTER. (A new set

1. Press MENU and open the PREFERENCES menu.

of INSTALLATION menu icons will appear on-screen, as

shown in step 3 below.)

2. Highlight MENU LANGUAGE and press ENTER.

3. Highlight your preferred menu language in the menu

sidebar and press ENTER.

Setup

Installation

Sleep Timer

On/Off Timer

HDMI Audio Selection

Auto

Preferences

Side Show Interval

2 Sec

AVHD Skip Time

15 min

Convergence

Favorite Channels

English

Closed Caption Mode

Off

Español

DVD RTN

Closed Caption Advanced

Français

Navigate

Select

Back

EXIT

Exit

CH RTN

Input Labeling

Menu Language

English

3. Open the TERRESTRIAL menu, highlight INPUT

DVD RTN

Navigate

Select

Back

EXIT

Exit

CH RTN

4. Press EXIT to close the PREFERENCES menu.

CONFIGURATION, and press ENTER.

Note: The TERRESTRIAL menu may not be accessible

(items will be “grayed out”) in some instances (for example, if

a cable box is connected to the ANT 1 input or if one of the

VIDEO modes is the current input during TV Guide On

Screen setup).

Terrestrial

Input Configuration

Channel program

Channel Add/Delete

Signal Meter

DVD RTN

Navigate

Select

Back

EXIT

Exit

CH RTN

4. Press • to select the input source (Cable or antenna) for the ANT 1 input on the TV.

Note: If a cable box is connected to the ANT 1 input during TV Guide On Screen setup, the entire TERRESTRIAL menu will not be accessible, including the input source for ANT 1, which will automatically display “Cable Box.”

5. Press z and then • to select the input source (Cable or antenna) for the ANT 2 input on the TV, if applicable. If you have not connected anything to ANT 2, skip this step.

Input Configuration

Antenna 1 In	Cable
Antenna 2 In	Antenna
Save	Cancel

6. To save your new settings: Highlight SAVE and press

ENTER.

To revert to your original settings: Highlight CANCEL and press ENTER before saving.

40		Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
H94(E)040-43(6a-Setup)	40	8/3/04, 5:22 PM

(E) 51/57/65H94