Toshiba 51H94 owner manual Setting the sleep timer, Displaying TV setting information on-screen

Chapter 8: Using the TV’s features

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length of time (maximum of 3 hours).

The sleep timer turns off the TV one time only, as opposed to the ON/OFF timer, which turns off the TV on a recurring basis.

To set the sleep timer:

Press SLEEP on the remote control to set the length of time until the TV turns off. Each time you press SLEEP, the time will increase in 10-minute increments, to a maximum of 180 minutes.

To cancel the sleep timer:

Press SLEEP until it is set to 0.

SLEEP

+10

–

ACTION 100 MENU

ENTER

To set the sleep timer using the on-screen menus:

1.Press MENU and open the SETUP menu.

2.Press z to highlight SLEEP TIMER and press ENTER.

Setup

Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection				Auto
Side Show Interval			2 Sec
AVHD Skip Time			15 min
Convergence
				DVD RTN
	Navigate	Select			Back	EXIT	Exit
				CH RTN

3.Press the Number buttons to enter the length of time until the TV turns off automatically.

Sleep Timer

Enter total minutes until the TV turns off automatically(Maximum 180 minutes)

1 8 0

SaveCancel

4. Highlight SAVE and press ENTER.

Note:

•When a power failure occurs, the sleep timer setting may be cleared.

•To display the amount of time left on the sleep timer, press

RECALL.

Displaying TV setting information on-screen

Press RECALL to display the following information on-screen:

¥Current input (ANT 1, ANT 2, VIDEO 1, etc.)

¥If ANT 1 or ANT 2 is the current input, whether it is Cable TV (ÒCABLEÓ) or off-air (ÒTVÓ)

¥Channel number (if in ANT 1 or ANT 2 mode)

¥	Time (if set)				33435
¥	Timer settings (if set)	STEREO
		TV – PG	L	V
¥	Remaining time on sleep	On Timer: Every Day 6:00am
		Sleep Timer: 60 min.
	timer (if set)
¥	Remaining time on game				ANT1
	timer (if set)	Full		5:09 pm	CABLE 2
¥	Stereo or SAP audio
		Sample RECALL screen
	status

¥V-Chip rating status

¥Picture size

Understanding the auto power off feature

The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT 1 and ANT 2 modes only.

Understanding the last mode memory feature

If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied.

NOTE: Because the Last Mode Memory feature will cause the TV to turn on after a power failure (if it was on when the power failed), if you are viewing fixed images or special formats when the power fails, such images or formats could be displayed when the power returns. To prevent possible damage to the TV’s picture tube, you should unplug the TV’s power cord if it is possible that you will be away from the TV for an extended period of time after the power is restored. If you are away, the TV could turn on automatically, displaying fixed images or special formats that can become permanently engrained in the picture tube. THIS TYPE OF DAMAGE IS NOT COVERED BY YOUR WARRANTY. See item 33 on page 4.

		Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.	87
H94(E)084-87(8c-UseTV)	87	8/3/04, 6:44 PM

(E) 51/57H94