Toshiba 62HM15A owner manual Installation from previous, Care from previous column, Service Center

Page 4

Installation (continued from previous page)

27)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

 

Antenna lead-in wire

 

Antenna discharge unit

Ground clamp

(NEC Section 810-20)

 

 

Grounding conductors

Electric Service Equipment

(NEC Section 810-21)

 

 

Power ser vice grounding

Ground clamps

electrode system (NEC Art 250 Par

 

28)DANGER: RISK OF SERIOUS PERSONAL INJURY OR DEATH!

• Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity: a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

29)Always sit approximately 10–25 feet away from the TV and as directly in front of it as possible. The picture can appear dull if you sit too far to the left or right of the TV, or if sunlight or room lights reflect on the screen. Turn the TV off to check for reflections on the screen, and then remove the source of reflections while viewing the TV.

30)Always unplug the TV before cleaning. Never use liquid or aerosol cleaners. Clean only with a soft, dry cloth.

Do not spray volatile compounds, such as insecticide, on the cabinet. This may discolor or damage the cabinet.

31)WARNING: RISK OF ELECTRIC SHOCK!

Never spill liquids or push objects of any kind into the TV cabinet slots.

32)If the air temperature rises suddenly (for example, when the TV is first delivered), condensation may form on the lenses. This can make the picture appear distorted or the color appear faded. If this happens, turn off the TV for 6 to 7 hours to allow the condensation to evaporate.

4

Care (continued from previous column)

33)For added protection of your TV from lightning and power surges, always unplug the power cord and disconnect the antenna from the TV if you leave the TV unattended or unused for long periods of time.

34) During normal use, the TV may make occasional snapping

 

or popping sounds. This is normal, especially when the

 

unit is being turned on or off. If these sounds become

 

frequent or continuous, unplug the power cord

 

and contact a Toshiba Authorized Service Center.

35)

Special care for Texas Instruments Digital Light

 

Processing™ (DLP) lamp units:

 

• The lamp in this product has a limited service life. The

 

length of service life varies depending on product use or

 

user settings. If you use the lamp beyond its service life:

 

you may notice a reduction in the colors and/or

 

brightness of the picture, at which time you should

 

 

 

 

replace the lamp unit; and

 

the strength of the quartz glass in the lamp will be

 

reduced and the lamp may rupture. If the lamp

 

 

 

 

ruptures, the TV will not operate until the lamp unit is

 

 

replaced.

 

See “Lamp unit replacement and care” on pages 103–105.

Dispose of the used lamp unit by the approved method for your area.

The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental

 

considerations. For disposal or recycling

 

information, please contact your local authorities or

 

the Electronic Industries Alliance (www.eiae.org).

Service

36)

WARNING: RISK OF ELECTRIC SHOCK!

 

Never attempt to service the TV yourself,

 

except as specified on pages 103–105.

 

Opening and removing the covers may expose you to

 

dangerous voltage or other hazards. Failure to follow this

 

WARNING may result in death or serious injury. Refer all

 

servicing not specified in this manual to a Toshiba Authorized

 

Service Center.

37)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

38)When the TV reaches the end of its useful life, ask a

qualified service technician to properly dispose of the TV.

Note: The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental considerations. Dispose of the used lamp unit by the approved method for your area. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance (www.eiae.org).

__________

Digital Light Processing, DLP™ and the DLP medallion are trademarks of Texas Instruments.

Downloaded from www.Manualslib.com manuals search engine

Image 4
Contents 46HM15 62HM15A Safety Precautions 46HM15 ST4605 62HM15A ST6214Installation, Care, and Service Important Safety InstructionsOn next Installation from previous Never attempt to service the TV yourselfService Center Care from previous columnContents Setting up and using TheaterNet on-screen Using the TV Guide On ScreenFeatures of your new TV IntroductionWelcome to Toshiba See Important notes about your DLP projection TV onSee LED indications on Connecting your TV Power Press to turn the TV on and offTV front touchpad and side panel controls and connections Green and Red LEDsTV back panel connections 7 !¡Overview of cable types To a Personal Computer PCYou will need To view encrypted digital channelsTV back panel Connecting a VCR and antenna or Cable TV no Cable box Connecting a camcorderConnecting a VCR and Cable box To view basic Cable channels and use the TV’s featuresOn Screen recording features To view basic and premium Cable channelsConnecting a VCR and satellite receiver One signal splitter Four coaxial cablesSelect the ColorStream HD-1 video input source on the TV To view the VCR or view and record antenna channelsTo view the DVD player To view premium Cable channelsFrom antenna or Cable TV Your TV has ColorStream component video inputs To view antenna or Cable channelsTo record a TV program while watching a DVD From antenna or CableConnecting two VCRs Select the ANT-1 video input source on the TVTo view VCR To dub or edit from VCR 1 to VCRConnecting an Hdmi or a DVI device to the Hdmi input One Hdmi cable type a connector per Hdmi deviceSee Setting the Hdmi audio mode on To connect an Hdmi device, you will needConnecting an analog audio system Connecting a digital audio systemTo control the audio To connect the IR blaster cable TheaterNet on-screen device controlTo control the devices Connecting IEEE1394 video devices Using analog-compatible IEEE1394 devicesSupported signals Using TheaterNet on-screen device controlIEEE1394 device initialization When you connect a D-VHS or Avhd device to the TVOn Screen interactive program guide built in to this TV To edit the IEEE1394 device information IEEE1394 device managementHighlight the device you want to edit and press Enter To connect to the G-LINK terminal LINKconnectionSee Chapter Learning about the remote control Using the remote controlKey for a function that is not available Point remote control Toward remote sensor On front of TV Remote control and the TVThere is no obstruction between To install the remote control batteries Installing the remote control batteriesDevice mode control after programming Remote Control functional key chart PowerAudio VCR Mute Device code setup Searching and sampling the code of a deviceNumbers CH y VOL yUsing the volume lock feature Operational feature resetRepeatedly press Mode to select CABLE/SAT mode To reset the volume controls to the original device modeVCRs/PVRs Multi-brand remote control device codesCable boxes CD players ReceiversLaser disks DVD playersMenu layout and navigation Main menu layoutSetup / Installation menu layout Buttons yzx on the remote Control or TV front panel to moveNavigating the menu system You can use the buttons on the remoteSetting up the TV Guide On Screen system To set up the TV Guide On Screen systemScreen 3 Do you have Cable service connected? Screen 1 Select the TV location USA, and then pressIf you select Video 1, screen 7 appears For additional details, seeSetting up the TV Guide On Screen system If the information is incorrect, select No, repeat setup TV Guide On Screen system setup. Press Enter toWhen you turn on the TV. To turn off the automatic Use the x buttons to select the Setup menuSetting up your TV Configuring the antenna input sourcesTo configure the ANT 1 and ANT 2 input sources Selecting the menu languageProgramming channels automatically Programming channels into the TV’s channel memoryTo program channels automatically Manually adding and deleting channels in the channel memory Programming your favorite channels To add and delete channels in the Favorite Channels setsTo clear your favorite channel ListsSetting up and using TheaterNet on-screen device control Setting up TheaterNetTo set up TheaterNet device control TheaterNet Setup menu opensUsing the TheaterNet control icons To select the device’s control icons directlyTo close the on-screen control icons To view another sourceTheaterNet IR device codes AmplifiersLaser disk players Miscellaneous audio devicesVideo accessory Hdtv decoder VCRsBrand Setting the time and date Setting the Avhd device skip timeSetting the Hdmi audio mode Setting the Quick Restart Feature To set the Quick Restart featureViewing the CableCARD menu To view the CableCARD menuViewing the digital signal meter Viewing the system statusTV Guide On Screen system includes the following features To open the TV Guide On Screen systemRating, stereo, HDTV, new episode InstructionsTV Guide On Screen remote control functions Navigating the TV Guide On Screen systemVideo Window Panel MenusSystem, the current program appears in the Video Window Lock/unlock icon indicates the status of the Video WindowTV Guide On Screen Icons Info Box¥ Show is presented in high-definition TV, if available TV Guide On Screen Services Listings screenSearch screen Example Category searchList of all matching shows for that keyword is displayed To edit or delete a keywordFor additional details, see Record features on Recordings screenTo choose the way recordings are displayed To view a recording, you can do one of the followingRecord features Set a show to Record from a panel menuSchedule screen Est recordingDon’t Record This Show-Cancels the Recording Highlight NEW Manual Recording and pressShow previously set to Record Enter to display the Record Options panel menuSet a show Reminder from a panel menu Remind featuresManually set a show Reminder Reminder notification banner Change system settings Setup screenChange channel display Change default options General defaultsRecord defaults Remind defaultsUsing the TV’s features Selecting the video input source to viewTo select the video input source to view Source can be hidden. See page 68 for detailsLabeling the video input sources DTV Satellite/DSS Cable Game ConsoleTo label the video input sources To clear the input labelsTuning channels Using the Channel BrowserTo toggle between Browse mode and Select mode To tune to a channel in Browse modeTo set a channel as Home using the remote control To set a channel as Home using the menusTo tune to the Home channel Adding channels to the channel historyTuning your favorite channels Tuning to the next programmed channelSwitching between two channels using Channel Return Switching between two channels using SurfLockSelecting the picture size To select the picture sizeScrolling the TheaterWide picture on None of the picture is hiddenTheaterWide 1 picture size For 43 format program TheaterWide 2 picture size for letter box programsUsing the auto aspect ratio feature To set the scroll settingsTo turn on the auto aspect ratio feature To turn off the auto aspect ratio featureSelecting the lamp mode To set the Cinema Mode to FilmTo set the Cinema Mode to Video To select the lamp modeUsing the POP features Using the POP double-window featureTo display a program in the POP window To close the POP window and tune to the highlighted windowPOP double-window aspect ratio Switching the speaker audio main or POPAspect ratio is the ratio of width to height of the picture Using the Freeze feature Using the favorite channel scan featureTo scan and tune your favorite channels Highlight the window for the channel you want to viewSelecting the picture mode Adjusting the pictureAdjusting the picture quality Using CableClear/DNR digital noise reduction Selecting the color temperatureTo select the color temperature To select CableClear/DNR preferencesUsing Mpeg noise reduction Using dynamic contrastTo select the Mpeg noise reduction level To select dynamic contrast preferencesUsing the closed caption mode Advanced closed captionsTo select digital closed captions Digital closed captionsPress Menu and open the Applications menu Adjusting the audio Using the digital audio selectorMuting the sound Selecting stereo/SAP broadcastsUsing the sub-bass system SBS Adjusting the audio qualityUsing the StableSound feature Turning off the built-in speakers Using the SRS WOW surround sound featureSelecting the optical audio output format Using the memory card Jpeg picture viewer/MP3 audio player Memory card specificationsUsing the Jpeg picture viewer To view digital photos on your TVPress x to rotate the large picture 90 counterclockwise Press to rotate the large picture 90 clockwiseUsing the MP3 audio player To set the slide show intervalTo close the picture viewer To close the picture viewer and remove the memory cardMemory card care and handling Volume, and mute buttons, and then press EnterTo close the MP3 audio player To set the sleep timer Setting the On/Off Timer Setting the sleep timerTo cancel the sleep timer Understanding the auto power off feature Understanding the last mode memory featureUsing the gray level feature Displaying the Channel BannerUsing the Locks menu Entering the PIN codeIf you cannot remember your PIN code Changing your PIN codeBlocking TV programs and movies by rating V-Chip To block and unblock TV programs and moviesPress z to highlight Edit Rating Limits and press Enter Independent rating system for broadcastersUnlocking programs temporarily Blocking channelsLocking video inputs Using the GameTimer Using the front panel lock featureTroubleshooting To SAP mode Closed caption problemsFeature V-Chip feature is available for the U.S. V-Chip system onlyLED indications TV Guide On Screen FAQs Setup101 TV Guide On Screen FAQs On Screen system?Lamp unit replacement and care When to replace the lamp unitAppendix Replacing the lamp unitHow to replace the lamp unit Grasp the lamp unit handle and gently pull the lamp unitDisposing of the used lamp unit Call Tacp Consumer Solutions atReplace the thumb screw and hand-tighten Specifications Television SystemLimited United States Warranty For DLP Television Models108 109 Channel programming Index87Ð90 Picture adjustments Picture-out-picture POP2Ð5 106Toshiba America Consumer PRODUCTS, L.L.C
Related manuals
Manual 112 pages 972 b