Toshiba 62HM15A owner manual Using the memory card Jpeg picture viewer/MP3 audio player

Page 87

Chapter 8: Using the TV’s features

Using the memory card JPEG picture viewer/MP3 audio player

You can use the memory card slots on the TV side panel to view compatible JPEG files or play compatible MP3 files stored on a memory card (see “Memory card specifications” below and at right). You can display JPEG files in thumbnail mode or view them as a slide show.

Note:

Never remove the memory card or turn off the TV while using the memory card. Doing so may result in loss of data and/or damage to the memory card and/or TV. SUCH DAMAGE IS NOT COVERED BY YOUR TOSHIBA WARRANTY.

It is recommended that you back up your memory card data. Toshiba is not liable for any damage caused by the use of any memory card with this TV. Toshiba will not compensate for any lost data or recording(s) caused by the use of such cards.

For instructions on using your digital camera, refer to the owner’s manual for your camera.

For instructions on using your memory card, refer to the owner’s manual for your memory card.

Failure to take proper care of a memory card may prevent display of pictures or playback of MP3 files from the card or result in damage to the memory card and/or TV. SUCH DAMAGE IS NOT COVERED BY YOUR TOSHIBA WARRANTY. See “Memory card care and handling” on page 90.

The technical criteria set out in this owner’s manual are meant as a guide only.

You must obtain any required permission from copyright owners to download or use copyrighted content.Toshiba cannot and does not grant such permission.

Memory card specifications

Supported memory card types:

Memory Card (ver. 1.0)

MMC (MultiMediaCard)

MemoryStick(Pro)

xD-Picture Card(16MB-512MB)

CompactFlash® memory card (Type1)

Note: The picture viewer and audio player support FAT16 formatted cards only. Other memory card formats (including, but not limited to, FAT32 and NTFS) are not supported.

______________

is a trademark.

MMC and MultiMediaCard are trademarks of Infineon Technologies AG and licensed to MMCA (MultiMediaCard Association).

Memory Stick is a trademark of Sony Corporation.

xD-Picture Card is a trademark of Fuji Photo Film Co., Ltd.

Toshiba is an authorized licensee of the CompactFlash® and CF logo® registered trademarks.

Maximum memory card capacity: 512 MB.

Maximum displayable JPEG image size: 8 MB.

JPEG files larger than 8 MB will not display.

Maximum MP3 file size: 50 MB

MP3 files larger than 50 MB will not play.

Maximum displayable JPEG image resolution: 6000x4000 pixels.

Maximum number of files per directory: 370.

All files over the 370th in a single directory will not display/play.

Files in directories more than 10 levels down from the top level directory will not display/play.

Maximum number of files per memory card: JPEG = 1,000; MP3 = 200.

All JPEG files over the 1,000th on a single memory card will not display.

All MP3 files over the 200th on a single memory card will not play.

File name restrictions:

File names cannot contain the following characters: \ / : ? “ < > .

File names must contain US-ASCII characters only.

The maximum file name length is 255 characters.

The memory card reader recognizes only “.mp3” and “.jpg” file extensions.

The MP3 player supports only ISO-8859-1 (US-ASCII/Western European) character sets for MP3 meta-data (e.g, artist name, album name, song title, etc.)

JPEG picture viewer:

The picture viewer supports JPEG format images only.

The files on your memory card must be in a file and directory format compatible with the TV or they will not display on the TV.

Images processed and/or edited on a personal computer (PC) may not display properly or at all. Some digital cameras may store images in a format that is not compatible with the TV.

MP3 audio player:

The audio player supports MP3 format files only.

The files on your memory card must be in a file and directory format compatible with the TV or they will not play.

Files processed and/or edited on a personal computer (PC) may not play properly or at all. Some MP3 files may be in a format that is not compatible with the TV.

MP3 files must have the following format:

-MPEG1 (ISO/IEC 11172-3) Layer3.

-Sampling frequency—MPEG1: 32 kHz, 44.1 kHz, 48 kHz.

-Bitrate—MPEG1: 32–320 kbps.

-Channels—Stereo, Joint stereo, Dual channel, Single channel.

-ID3 Ver. 1, Ver. 2.

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

87

 

Downloaded from www.Manualslib.com manuals search engine

Image 87
Contents 46HM15 62HM15A 46HM15 ST4605 62HM15A ST6214 Safety PrecautionsImportant Safety Instructions Installation, Care, and ServiceOn next Care from previous column Installation from previousNever attempt to service the TV yourself Service CenterContents Using the TV Guide On Screen Setting up and using TheaterNet on-screenSee Important notes about your DLP projection TV on Features of your new TVIntroduction Welcome to ToshibaSee LED indications on Green and Red LEDs Connecting your TVPower Press to turn the TV on and off TV front touchpad and side panel controls and connections7 !¡ TV back panel connectionsTo a Personal Computer PC Overview of cable typesTo view encrypted digital channels You will needTV back panel Connecting a camcorder Connecting a VCR and antenna or Cable TV no Cable boxTo view basic and premium Cable channels Connecting a VCR and Cable boxTo view basic Cable channels and use the TV’s features On Screen recording featuresTo view the VCR or view and record antenna channels Connecting a VCR and satellite receiverOne signal splitter Four coaxial cables Select the ColorStream HD-1 video input source on the TVTo view premium Cable channels To view the DVD playerFrom antenna or Cable TV From antenna or Cable Your TV has ColorStream component video inputsTo view antenna or Cable channels To record a TV program while watching a DVDTo dub or edit from VCR 1 to VCR Connecting two VCRsSelect the ANT-1 video input source on the TV To view VCRTo connect an Hdmi device, you will need Connecting an Hdmi or a DVI device to the Hdmi inputOne Hdmi cable type a connector per Hdmi device See Setting the Hdmi audio mode onConnecting a digital audio system Connecting an analog audio systemTo control the audio TheaterNet on-screen device control To connect the IR blaster cableTo control the devices Using TheaterNet on-screen device control Connecting IEEE1394 video devicesUsing analog-compatible IEEE1394 devices Supported signalsWhen you connect a D-VHS or Avhd device to the TV IEEE1394 device initializationOn Screen interactive program guide built in to this TV IEEE1394 device management To edit the IEEE1394 device informationHighlight the device you want to edit and press Enter LINKconnection To connect to the G-LINK terminalSee Chapter Using the remote control Learning about the remote controlKey for a function that is not available Remote control and the TV Point remote control Toward remote sensor On front of TVThere is no obstruction between Installing the remote control batteries To install the remote control batteriesDevice mode control after programming Power Remote Control functional key chartAudio VCR Mute CH y VOL y Device code setupSearching and sampling the code of a device NumbersTo reset the volume controls to the original device mode Using the volume lock featureOperational feature reset Repeatedly press Mode to select CABLE/SAT modeMulti-brand remote control device codes VCRs/PVRsCable boxes DVD players CD playersReceivers Laser disksMain menu layout Menu layout and navigationYou can use the buttons on the remote Setup / Installation menu layoutButtons yzx on the remote Control or TV front panel to move Navigating the menu systemScreen 1 Select the TV location USA, and then press Setting up the TV Guide On Screen systemTo set up the TV Guide On Screen system Screen 3 Do you have Cable service connected?For additional details, see If you select Video 1, screen 7 appearsSetting up the TV Guide On Screen system Use the x buttons to select the Setup menu If the information is incorrect, select No, repeat setupTV Guide On Screen system setup. Press Enter to When you turn on the TV. To turn off the automaticSelecting the menu language Setting up your TVConfiguring the antenna input sources To configure the ANT 1 and ANT 2 input sourcesProgramming channels into the TV’s channel memory Programming channels automaticallyTo program channels automatically Manually adding and deleting channels in the channel memory Lists Programming your favorite channelsTo add and delete channels in the Favorite Channels sets To clear your favorite channelTheaterNet Setup menu opens Setting up and using TheaterNet on-screen device controlSetting up TheaterNet To set up TheaterNet device controlTo view another source Using the TheaterNet control iconsTo select the device’s control icons directly To close the on-screen control iconsMiscellaneous audio devices TheaterNet IR device codesAmplifiers Laser disk playersVCRs Video accessory Hdtv decoderBrand Setting the Avhd device skip time Setting the time and dateSetting the Hdmi audio mode To view the CableCARD menu Setting the Quick Restart FeatureTo set the Quick Restart feature Viewing the CableCARD menuViewing the system status Viewing the digital signal meterInstructions TV Guide On Screen system includes the following featuresTo open the TV Guide On Screen system Rating, stereo, HDTV, new episodeNavigating the TV Guide On Screen system TV Guide On Screen remote control functionsLock/unlock icon indicates the status of the Video Window Video WindowPanel Menus System, the current program appears in the Video WindowInfo Box TV Guide On Screen Icons¥ Show is presented in high-definition TV, if available Listings screen TV Guide On Screen ServicesExample Category search Search screenTo edit or delete a keyword List of all matching shows for that keyword is displayedTo view a recording, you can do one of the following For additional details, see Record features onRecordings screen To choose the way recordings are displayedEst recording Record featuresSet a show to Record from a panel menu Schedule screenEnter to display the Record Options panel menu Don’t Record This Show-Cancels the RecordingHighlight NEW Manual Recording and press Show previously set to RecordRemind features Set a show Reminder from a panel menuManually set a show Reminder Reminder notification banner Setup screen Change system settingsChange channel display Remind defaults Change default optionsGeneral defaults Record defaultsSource can be hidden. See page 68 for details Using the TV’s featuresSelecting the video input source to view To select the video input source to viewTo clear the input labels Labeling the video input sourcesDTV Satellite/DSS Cable Game Console To label the video input sourcesTo tune to a channel in Browse mode Tuning channelsUsing the Channel Browser To toggle between Browse mode and Select modeAdding channels to the channel history To set a channel as Home using the remote controlTo set a channel as Home using the menus To tune to the Home channelSwitching between two channels using SurfLock Tuning your favorite channelsTuning to the next programmed channel Switching between two channels using Channel ReturnTo select the picture size Selecting the picture sizeTheaterWide 2 picture size for letter box programs Scrolling the TheaterWide picture onNone of the picture is hidden TheaterWide 1 picture size For 43 format programTo turn off the auto aspect ratio feature Using the auto aspect ratio featureTo set the scroll settings To turn on the auto aspect ratio featureTo select the lamp mode Selecting the lamp modeTo set the Cinema Mode to Film To set the Cinema Mode to VideoTo close the POP window and tune to the highlighted window Using the POP featuresUsing the POP double-window feature To display a program in the POP windowSwitching the speaker audio main or POP POP double-window aspect ratioAspect ratio is the ratio of width to height of the picture Highlight the window for the channel you want to view Using the Freeze featureUsing the favorite channel scan feature To scan and tune your favorite channelsAdjusting the picture Selecting the picture modeAdjusting the picture quality To select CableClear/DNR preferences Using CableClear/DNR digital noise reductionSelecting the color temperature To select the color temperatureTo select dynamic contrast preferences Using Mpeg noise reductionUsing dynamic contrast To select the Mpeg noise reduction levelAdvanced closed captions Using the closed caption modeDigital closed captions To select digital closed captionsPress Menu and open the Applications menu Selecting stereo/SAP broadcasts Adjusting the audioUsing the digital audio selector Muting the soundAdjusting the audio quality Using the sub-bass system SBSUsing the StableSound feature Using the SRS WOW surround sound feature Turning off the built-in speakersSelecting the optical audio output format Memory card specifications Using the memory card Jpeg picture viewer/MP3 audio playerPress to rotate the large picture 90 clockwise Using the Jpeg picture viewerTo view digital photos on your TV Press x to rotate the large picture 90 counterclockwiseTo close the picture viewer and remove the memory card Using the MP3 audio playerTo set the slide show interval To close the picture viewerVolume, and mute buttons, and then press Enter Memory card care and handlingTo close the MP3 audio player Setting the On/Off Timer Setting the sleep timer To set the sleep timerTo cancel the sleep timer Displaying the Channel Banner Understanding the auto power off featureUnderstanding the last mode memory feature Using the gray level featureChanging your PIN code Using the Locks menuEntering the PIN code If you cannot remember your PIN codeIndependent rating system for broadcasters Blocking TV programs and movies by rating V-ChipTo block and unblock TV programs and movies Press z to highlight Edit Rating Limits and press EnterBlocking channels Unlocking programs temporarilyLocking video inputs Using the front panel lock feature Using the GameTimerTroubleshooting V-Chip feature is available for the U.S. V-Chip system only To SAP modeClosed caption problems FeatureLED indications Setup TV Guide On Screen FAQs101 On Screen system? TV Guide On Screen FAQsReplacing the lamp unit Lamp unit replacement and careWhen to replace the lamp unit AppendixGrasp the lamp unit handle and gently pull the lamp unit How to replace the lamp unitCall Tacp Consumer Solutions at Disposing of the used lamp unitReplace the thumb screw and hand-tighten Television System SpecificationsFor DLP Television Models Limited United States Warranty108 109 Index Channel programming87Ð90 106 Picture adjustmentsPicture-out-picture POP 2Ð5Toshiba America Consumer PRODUCTS, L.L.C
Related manuals
Manual 112 pages 972 b