Toshiba 62HM15A owner manual Programming channels into the TV’s channel memory

Chapter 6: Setting up your TV

Programming channels into the TV’s channel memory

When you press CHANNEL y or z on the remote control or TV front panel, your TV will stop only on the channels stored in the TV’s channel memory.

4.Open the Terrestrial menu, highlight Channel Program, and press ENTER.

Follow the steps below to program channels into the TV’s channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels.

Note:

•	You must configure the antenna input sources before
	programming channels (see page 41).
•	If the input signal type is set to CABLE for an antenna input, the

5.Highlight ANT 1 or ANT 2, depending on which antenna input you want to program channels for, and then press ENTER to start automatic channel programming.

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate Select CH RTN Back EXIT Exit

ANT 1 Antenna

Scanning channels, please wait ...

52%

Abort

automatic channel programming process erases channels that

were previously programmed into the TV’s memory.

• If the input signal type is set to ANTENNA, the automatic

channel programming process does NOT erase channels that

were previously programmed into the TV’s memory, but adds

newly found channels to the existing set of programmed

channels. To remove a channel from the memory, you must

manually delete it (see next page).

• To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the

remote control.

• Programming channels for an antenna input configured for

CABLE will take substantially longer than for an antenna input

configured for ANTENNA. This is normal; however, once

channel programming is completed, you should not have to

repeat the programming process again unless your Cable TV

service lineup changes significantly.

• If you have a CableCARD™ inserted (page 12), channel

programming for ANT 1 is disabled because the CableCARD™

automatically loads the Cable channel list into the TV’s channel

memory.

To program channels automatically:

1.Make sure you have configured the antenna input sources. See page 41 for details.

2.Press MENU and open the Setup menu.

3.Highlight Installation and press ENTER. (A new set of Installation menu icons will appear on-screen).

Setup

Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio		Auto
HDMI 2 Audio		Auto
Slide Show Interval		2 Sec
AVHD Skip Time		15 min
Navigate	Select CH RTN Back EXIT Exit

The TV will automatically cycle through all the channels for the antenna input you selected, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait” appears (as shown above).

6.To cancel channel programming, either press EXIT or highlight Abort in the on-screen display and press ENTER.

When channel programming is done, press CHANNEL y or z to view the programmed channels.

Channel

Numbers

CHANNEL yz

TV front touchpad

CHANNEL z / y	MENU
	(ENTER)

42 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Downloaded from www.Manualslib.com manuals search engine