Toshiba 62HM15A Using CableClear/DNR digital noise reduction, Selecting the color temperature

Chapter 8: Using the TV’s features

Adjusting the picture (continued)

Using CableClear®/DNR (digital noise reduction)

The CableClear®/DNR digital noise reduction feature allows you to reduce visible interference in your TV picture. This may be useful when receiving a broadcast with a weak signal (especially a Cable channel) or playing a noisy video cassette or disc. This feature is enabled for 480i signals only.

NOTE: The CableClear®/DNR feature does not function in ColorStream, HDMI (DVI), ATSC, IEEE1394, and digital Cable modes.

To select CableClear/DNR preferences:

1.Press MENU and open the Video menu.

2.Highlight Advanced Picture Settings and press ENTER.

3.Press z to highlight the CableClear/DNR field, and then press x or • to make a selection.

Video

Picture Settings

Advanced Picture Settings

Theater Settings

Advanced Picture Settings				ANT 1
	Dynamic Contrast		On
	MPEG Noise Reduction		Low
	CableClear		Auto
	Color Temperature		Cool
	Lamp Mode		Low Power
		Reset	Done

Note:

•If the current input is Antenna, Video 1, Video 2, or Video 3, the menu will display the text “CableClear.” The available selections are Off, Low, Middle, High, and Auto.

•If the current input is ColorStream HD1, ColorStream HD2, or HDMI, and the video resolution is 480i, the menu will display the text “DNR.” The available selections are Off, Low, Middle, High, and Auto. Auto will react proportionally to the strength of the noise. Low, Middle, and High will reduce the noise in varying degrees from lowest to highest, respectively.

•If the current input is ColorStream HD1, ColorStream HD2, or HDMI, and the video resolution is not 480i, the menu will display the text “DNR” and will be “grayed out” with “Off” selected.

4.To save the new settings, highlight Done and press ENTER. To revert to the factory defaults, highlight Reset and press ENTER.

Selecting the color temperature

You can change the quality of the picture by selecting from three preset color temperatures (cool, medium, and warm), as described below.

Mode Picture Quality

cool blueish

medium neutral

warm reddish

To select the color temperature:

1.Press MENU and open the Video menu.

2.Highlight Advanced Picture Settings and press ENTER.

3.Press z to highlight the Color Temperature field, and then press x or • to select the mode you prefer (Cool, Medium, or Warm).

Video

Picture Settings

Advanced Picture Settings

Theater Settings

Advanced Picture Settings				ANT 1
	Dynamic Contrast		On
	MPEG Noise Reduction		Low
	CableClear		Auto
	Color Temperature		Cool
	Lamp Mode		Low Power
		Reset	Done

4.To save the new settings, highlight Done and press ENTER. To revert to the factory defaults, highlight Reset and press ENTER.

Note: If you select one of the factory-set picture modes (Sports, Standard, or Movie) and then change the color temperature, the picture mode automatically changes to Preference in the Picture Settings menu.

80 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Downloaded from www.Manualslib.com manuals search engine