GE 45608 manual Create Secondary Controller, To Change Advanced Configuration Settings, Value 1 =

To Change Advanced Configuration Settings:

1.Enter Z-Wave setup mode and highlight ADV. CONFIG.

2.Press OK and screen will display PARAMETER 0

3.Use either ARROW key to scroll until the display reads the proper parameter number (1 - 255) as indicated in the Z-Wave device’s instructions

4.Press OK and the screen will read NUMBER OF BYTES

5.Use either ARROW key to scroll until the display reads the proper number of bytes (1, 2 or 4) as indicated in the Z-Wave device’s instructions

6.Press OK and the screen will display read CONFIGURATION

VALUE 1 = 0

7.Use either ARROW key to scroll until the display reads the proper value (0 - 255) as indicated in the Z-Wave device’s instructions

8.Press OK

9.Press the button on the device.

10.The screen will display SUCCESSFUL

Copying information to or from the remote control:

Create Secondary, Controller Swap and Receive are all methods used in the process of replication.

Create Secondary Controller

A Primary controller must be used to add or delete devices from your network; however, secondary controllers can be created to enhance convenience (remotes in multiple locations like the kitchen, master bedroom and family room) and functionality (control of more than 18 individual lights, 18 groups or 18 scenes).

There are two ways to create a secondary controller. The first way is to copy all network and device information while the second is to copy just the network information. If the two remotes are identical (two of the GE 45608s for example), the first method creates an exact duplicate of all Z-Wave information including groups, scenes, labels, etc. The second method copies only the network and does not duplicate the groups, scenes, labels, etc.

	Transfer
Create	Controller
Secondary	Swap

Receive

38