GE 45608 manual Controller Swap Transfer Primary

Please refer to its instructions for details.

8.Change individual devices, groups, scenes, etc. on the new secondary remote as needed.

Controller Swap (Transfer Primary)

You can transfer all of your remote’s information to another remote, so it becomes the new Primary remote and the original remote becomes a secondary controller. You can do this in two ways: either transferring all information, or just transferring network information.

Transferring all Device, Network and Primary status to a new remote:

1.Enter Z-Wave setup mode and highlight TRANSFER

2.Press OK; the screen will display CREATE SECONDARY

3.Press the right ARROW key once; the screen will display

CONTROLLER SWAP.

4.Press OK; the screen will display ALL

5.Place the Secondary remote in RECEIVE mode. See the following section on “Receiving Network and Device Information” if the Secondary remote is a GE 45608 remote. If the Secondary remote is a different GE model or different brand, please refer to its instructions for details.

6.After the Secondary remote is in the RECEIVE mode press OK on the Primary remote; the screen will display SENDING. The Primary remote then transmits the network and device information to the new Secondary remote.

7.Both remotes should indicate a successful completion of the copying process.

a.The 45608’s screen will display SUCCESSFUL.

b.Other GE models or other brands will indicate success in various ways, depending on the remote’s capabilities. Please refer to its instructions for details.

Transferring only Network and Primary status to a new remote:

1.Enter Z-Wave setup mode and highlight TRANSFER

2.Press OK; the screen will display CREATE SECONDARY

3.Press the right arrow key once; the screen will display

CONTROLLER SWAP.

4.Press OK; the screen will display ALL

5.Press the right ARROW key once; the screen will display

NETWORK ONLY.

40