GE 45608 manual Resetting Your Network, Recovering Network Information, To reset your network

Reset

Network

Recovery	Update	Remove All
		Failed Nodes

Resetting Your Network

You can reset your network to clear all device and Z-Wave network information from the remote. This does not reset the Z-Wave devices to their factory default. Each device still needs to be deleted in order to reset them. Please refer to the section on “Deleting a Device (Node/Light) from Your Network” for details.

To reset your network:

1.Enter Z-Wave setup mode and scroll to NETWORK

2.Press OK; the screen will display RESET

3.Press OK; the screen will display RESETTING

4.When the screen displays SUCCESSFUL your remote has been reset.

5.Delete all individual devices to reset them to their factory defaults. This step must be completed in order to use the devices in a new network.

Recovering Network Information

This forces a re-discovery of all the devices in your network, verifies communications between devices and rebuilds the routing tables. The remote must be the Primary controller to perform this function. All secondary controllers should be updated using the “create secondary Controller” instructions after a successful network recovery. You must have at least 2 nodes in your network to perform a recovery.

To recover network information:

1.Enter Z-Wave setup mode and highlight NETWORK

2.Press OK; the screen will display RESET

3.Use the ARROW keys to scroll to RECOVER.

4.Press OK; the screen will display RECOVERING

5.When the screen displays SUCCESSFUL you have successfully recovered network information and rebuilt the routing tables

42