GRANITE180.6

u	u UndersIde View u

1.+I2V - Connected to fuse or circuit breaker, then battery’s positive post.

2.Ground - Main ground connection. Bolt to a clean chassis ground in the vehicle.

3.Remote - Remote turn-on input from the head unit. Accepts +12V

4.LED - Indicates amplifier power on.

5.Speaker Output Connections - Channels (1 + 2 )

6.Input Level - Variable from 1OOmV to 2.5V (Channels 1 + 2).

7.Inputs - Standard RCA-type connectors (Channels 1 + 2). Use only right channel for mono.

8.Speaker Output Connections - (Channels 3 + 4)

9.input level - Variable from 100mV to 2.5V (Channels 3 + 4).

10.Inputs - Standard RCA-type connectors (Channels 3 +4). Use only right channel for mono.

11.Speaker Output Connections - (Channels 5 + 6)

12.Input Level -Variablefrom IOOmV to 2.5V (Channels 5 + 6).

13.Inputs - Standard RCAtype connectors (Channels 5 +6). Use only right channel for mono.

14.[underside] Channels 5 + 6 Mono/Stereo (input 5 + 6) / Stereo (input 3 + 4) Switch

MONO position for single channel operation. (Only right channel is active in Mono) Use “STEREO5+6” for RCA inputs 5+6. Use “STEREO3+4” for input from RCAs 3+4.

15.[underside] Channels 5 + 6 Crossover - Full range or high pass (150Hz,12dB/octave).

16.[underside] Channels 3 + 4 Mono/Stereo (input 3 + 4) / Stereo (Input 3 + 4) Switch

MONO position for single channel operation. (Only right channel is active in Mono) Use either STEREO input position with RCA inputs from Channels 3 + 4.

17.[undersidejchannels 3 + 4 Crossover - Full range or high pass (150Hz, 12dB/octave).

18.[underside] Channels 1 + 2 Mono/Stereo (input I+ 2) / Stereo (input 3 + 4) Switch

MONO position for single channel operation (only right channel is active in Mono). Use “STEREO1+2” for RCA inputs 1+2. Use ‘STEREO 3+4” for input from RCAs 3+4.

19.[unde&de]Chann& 1 + 2 Crossover - Full range or low pass (75Hz, 12dB/octave).

20.[underside] Main Fuse - Main power supply fuse, replace only with same value.