
I N S T A L L A T I O N
Changing the Remote Code
The remote control contains three OPPO remote codes. The default is “Code 1”. If you have other OPPO products placed close to the
To select a new remote code, open the battery compartment cover of the remote control, and then use a ball point pen to flip the switch to one of the positions marked as “1”, “2”, or “3”. Close the battery compartment cover. Make sure that the
Battery Compartment
Remote Code Switch
Changing the Backlight Method
The remote control supports one of two backlight methods. By default, pressing the LIGHT button will turn on the backlight, and pressing any other button within 10 seconds will keep the backlight on. The alternative method will activate the backlight whenever any button is pressed; in this mode, the light will stay on for 10 seconds, and pressing any other button will keep the backlight on. To switch between these two backlight methods, press and hold the LIGHT button for 5 seconds.
CAUTION
ξNever drop the remote control or expose it to moisture.
ξNever expose the infrared remote sensor on the front panel to direct sunlight or other strong light sources.
ξRemote may not operate consistently when batteries become low. Replace them if operation deteriorates.
ξIf the remote control will not be used for a long time, please remove the batteries.
ξUse the batteries correctly to avoid possible leakage and corrosion. Do not leave the batteries exposed to direct sunlight or in a high temperature environment for a long period of time. Do not heat or expose to flame. Do not mix old and new batteries. Do not use batteries of different types at the same time. Do not attempt to recharge the batteries.
ξIf battery leakage occurs, do not touch the liquid with bare hands. Wipe out any liquid inside the battery compartment, and insert new batteries.
10