OPPO Digital BDP-105 user manual References

REFERENCES

Useful Notes

ξIn order to prolong the life of your player, it is recommended that you wait at least 30 seconds before you power it on after switching it off.

ξRemove discs and turn the power off after operation.

ξSome functions of the player may not be applicable to certain discs.

ξSome discs with special features may not be fully supported by the player. This is not a malfunction of the unit.

ξIn the case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the problem still exists, please follow the troubleshooting instructions or contact an OPPO service center.

Troubleshooting

Use this chart to resolve general operational problems. If there are any problems that you cannot resolve, please contact your OPPO service center.

							Reference
	Symptom		Possible Cause		Solution
							Page
			Audio cable is not properly	Check audio cable, and then reconnect if necessary.		11–19
			connected
			Mute is activated	Press the MUTE button to cancel the mute.		31
			Volume is too low	Press the VOL + button to increase the volume to 100.		30
			SACD is played and the audio	This is not supported due to copyright restrictions of
	No sound			SACD. Please use the analog or HDMI audio output.
		connection is coaxial or optical				19, 53
				Alternatively, you may set SACD Priority to CD mode
		digital audio
				and the player will play the CD layer.
			DVD-Audio is played and the	This is not supported due to copyright restrictions of
				DVD-Audio. Please use the analog or HDMI audio
		audio connection is coaxial or				19, 53
				output. Alternatively, you may switch to the DVD-
		optical digital audio
				Video playback mode.
			Video cable is not properly	Check video cable; reconnect if necessary.		11–15
			connected
			TV input is not correctly	Select the input to which the player is connected.
			selected
	No picture
			“Pure Audio” mode engaged	Press the PURE button to cancel this mode.		41
			Video output format is not	Select a proper output resolution that is supported by		34
			support by the TV	your TV.
			Video system is not supported	When playback is completely stopped, set the correct		56
		by the TV		TV System in the Setup Menu.
		Video system is not supported		When playback is completely stopped, set the correct		56
		by the TV		TV System in the Setup Menu.
	No color
			Saturation set too low	Check the saturation setting on TV and player.		60
			Incorrect video output port	If using “DIAG.” output, check that the cable is not		13
				incorrectly plugged into a component video jack.
	Incorrect color	Incorrect color space setting		If using HDMI for video output, check the color space		61
				setting on the TV and player.
	Picture rolling or	Video system is not supported		When playback is completely stopped, set the correct		56
	split picture	by the TV		TV System in the Setup Menu.
		No disc or incompatible disc		Eject disc and check.		27
		loaded in player
	“No Disc” or
			Dirty disc recording surface	Eject the disc and clean any dirt or fingerprints.		4
	“Unknown Disc”		Disc not properly loaded	Eject disc and make sure the label side is facing up		27
error				and the record side is facing down.
			Condensation on the Laser	Turn on the player, eject the disc and leave the player		2
			pick-up head	on for about an hour.

83